Ryobi DP103L Manuel d'utilisation et d'entretien télécharger pdf (Page 5)

5 - English

SPECIFIC SAFETY RULES

KEEP BITS CLEAN AND SHARP. Sharp bits minimize

stalling. Dirty and dull bits may cause misalignment of

the material and possible operator injury.

KEEP HANDS AWAY FROM WORK AREA. Keep hands

away from the bit. Restrain any loose clothing, jewelry,

long hair, etc., that may become entangled in the bit.

ALWAYS CLAMP WORKPIECE OR BRACE AGAINST

COLUMN TO PREVENT ROTATION. Never use your

hand to hold the object while drilling.

USE RECOMMENDED SPEED FOR DRILL ACCES-

SORY AND WORKPIECE MATERIAL.

BE SURE DRILL BIT OR CUTTING TOOL IS SECURELY

LOCKED IN THE CHUCK.

BE SURE CHUCK KEY IS REMOVED from the chuck

before connecting to power source or turning power ON.

ADJUST THE TABLE OR DEPTH STOP TO AVOID

DRILLING INTO THE TABLE. Shut off the power, remove

the drill bit, and clean the table before leaving machine.



AVOID DIRECT EYE EXPOSURE when using the laser

guide.

ALWAYS ENSURE THE LASER BEAM IS AIMED AT

A SURFACE WITH OUT REFLECTIVE PROPERTIES.

Shiny reflective materials are not suitable for laser use.

NEVER PLACE YOUR FINGERS IN A POSITION

WHERE THEY COULD CONTACT THE DRILL or other

cutting tool if the workpiece should unexpectedly shift.

NEVER PERFORM ANY OPERATION by moving the

head or table with respect to one another. Do not turn the

motor switch ON or start any operation before checking

that the head and table support lock handle is clamped

tight to column and head and table support collars are

correctly positioned.

BEFORE ENGAGING THE POWER SWITCH, MAKE

SURE THE BELT GUARD IS DOWN AND THE CHUCK

IS INSTALLED PROPERLY.

LOCK THE MOTOR SWITCH OFF WHEN LEAVING

THE DRILL PRESS. Do not perform layout, assembly, or

set-up work on the table while the cutting tool is rotating,

switched on, or connected to a power source.



IF THE POWER SUPPLY CORD IS DAMAGED, it must

be replaced only by the manufacturer or by an authorized

service center to avoid risk.

SAVE THESE INSTRUCTIONS. Refer to them frequently

and use to instruct other users. If you loan someone this

tool, loan them these instructions also.

WARNING:

This product and some dust created by power sanding, sawing, grinding, drilling, and other construction activities may

contain chemicals, including lead, known to the State of California to cause cancer, birth defects, or other reproductive

harm. Wash hands after handling.

Some examples of these chemicals are:

• lead from lead-based paints,

• crystalline silica from bricks and cement and other masonry products, and

• arsenic and chromium from chemically-treated lumber.

Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your

exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially

designed to filter out microscopic particles.

CALIFORNIA PROPOSITION 65

1 2 3 4 5 6 7 8 9 10 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Ryobi DP103L Manuel d'utilisation et d'entretien Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi DP103L