Ryobi SSP050 Manuel d'utilisateur télécharger pdf (Page 9)

9 — English

OPERATION

 Select the proper spray tip for desired spray pattern.

 Plug in the sprayer.

 Pull the switch trigger to spray paint. Release the switch

trigger to stop paint spray.

 Practice spraying on a piece of scrap material to test your

spray pattern and to prime the pump before beginning. If

you cannot get a good spray pattern with an even amount

of paint or stain throughout, refer to the Troubleshooting

section later in this manual.

NOTE: The pump must be primed after every paint

change and at ﬁrst use after storing. Spray paint at a

scrap surface for at least 20 seconds to prime.

To create an even coating over the entire surface:

• Move your arm at a steady rate of speed and make

sure to move your entire arm, not just your wrist.

• Keep the sprayer an even distance from the area

being sprayed, which should be between 8 to 10

inches from the tip of the sprayer to the surface

being sprayed.

• Depress the trigger to begin the spray off the

material you want to paint. Operate the sprayer in

straight horizontal or vertical strokes across the

surface being painted, then release the trigger off

the material to end the stroke.

NOTE: For spray quality consistency when using thinner

paints, it may be necessary to keep the trigger depressed

between strokes.

When ﬁnished, unplug the sprayer, return any unused

paint or stain to its original container, and thoroughly

clean the sprayer.

CAUTION:

It is important to thoroughly clean the sprayer after each

use or when changing colors. Allowing paint or stain to

remain in an idle tool for an extended period can cause

its moving pieces to seize up.

WARNING:

Do not clean with any ﬂammable liquids such as paint

stripper, paint remover, brush cleaner, mineral spirits,

lacquer thinner, turpentine, acetone, gasoline, kerosene,

etc.

CLEANING THE SPRAYER AFTER USE

The solution used to clean the sprayer is determined by

the type of material that has been sprayed. For anything

other than latex material, follow the material manufacturer’s

directions for appropriate clean-up.

To clean the sprayer for short term storage:

Unplug the sprayer.

 If you haven’t already done so, remove the paint container

and return any unused paint or stain to its original

container.

 Fill the paint container with lukewarm water (following

the use of latex products) or Klean-Strip

Revolutionary

White Formula Paint Thinner, or any other non-ﬂammable

paint thinner (following the use of oil-based products).

 Reinstall the paint container.

 Plug in the sprayer.

 Spray the solution onto a piece of cardboard or other

scrap material. Continue spraying until all the solution is

used.

Unplug the sprayer.

 Place a line of lubricant on the piston. To gain access to

the piston, follow the instructions in Cleaning the Sprayer

for Storage in the Maintenance section of this manual.

Use a damp cloth to wipe the exterior of the sprayer. The

unit is now ready to put away.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Ryobi SSP050 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi SSP050