Ryobi csb131 Manuel de l'opérateur télécharger pdf (Page 14)

OPERATION

STARTING/STOPPING THE SAW

See Figure 10.

To start the saw

: Depress the switch trigger.

Always let the blade reach full speed, then guide the saw

into the workpiece.

WARNING:

The blade coming in contact with the workpiece

before it reaches full speed could cause your saw to

“kickback” towards you resulting in serious injury.

To stop the saw

: Release the switch trigger.

After you release the switch trigger, allow the blade to

come to a complete stop. Do not remove the saw from

the workpiece while the blade is moving.

ADJUSTING BLADE DEPTH

See Figure 11.

Always keep correct blade depth setting. The correct

blade depth setting for all cuts should not exceed 1/4 in.

(6.35 mm) below the material being cut. More blade

depth will increase the chance of kickback and cause the

cut to be rough. For more depth of cut accuracy, a scale

is located on the upper blade guard.

Follow these directions to adjust the blade depth.

■ UNPLUG YOUR CIRCULAR SAW.

WARNING:

Failure to unplug the tool could result in accidental

starting causing serious injury.

■ Loosen depth adjustment knob.

■ Determine the desired depth of cut.

■ Locate depth of cut scale on back of upper blade

guard.

■ Hold base flat against the workpiece and raise or

lower saw until the indicator mark on bracket aligns

with notch on blade guard.

■ Tighten depth adjustment knob securely.

Fig. 10

Fig. 11

SWITCH

DEPTH

ADJUSTMENT

KNOB

DEPTH OF CUT

SCALE

BASE

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Commentaires sur ces manuels

Pas de commentaire

Ryobi csb131 Manuel de l'opérateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Ryobi csb131