Ryobi YG125CS Manuel d'utilisation et d'entretien télécharger pdf (Page 7)

7 — English

DANGER:

Do not use oxygen, combustible gases, or bottled gases

as a power source for this tool. The tool will explode and

cause death or serious injury.

WARNING:

Do not allow familiarity with this product to make you

careless. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields or goggles

marked to comply with ANSI Z87.1. Failure to do so could

result in fluids entering your eyes resulting in possible

serious injury.

WARNING:

Disconnect the tool from the air supply before leaving the

work area, moving the tool to another location, or handing

the tool to another person. Failure to do so could result

in serious personal injury.

APPLICATIONS

You may use this product for the purpose listed below:

 Finish and Trim (Interior and exterior)

 Floor Uderlayment

 Cabinet Work

 Casebacks

 Furniture

 Light Trim Moldings

 Fascia and Soffits

 Drawers

 Staircases

 Carpet installation

 Mirror and Picture Frames

 Crafts

 Lattice

WARNING:

Always wear eye protection. Eye protection does not fit

all operators in the same way. Make sure the eye protec-

tion chosen has side shields or provides protection from

flying debris both from the front and sides.

OPERATION

PREPARING THE TOOL FOR USE

See Figure 1, page 13.

This is an oil-free tool, therefore lubrication is not required.

However, the occasional addition of air tool lubrication into

the air fitting on the tool will not adversely affect performance

or harm the tool.

Before connecting the tool, check the air compressor gauge

to be sure it is functioning within the proper range of 70-

120 psi.

NO-MAR NOSEPIECE

See Figure 2, page 13.

The no-mar nosepiece attached to the workpiece contact

of the tool helps prevent marring and denting when working

with softer woods.

WARNING:

Disconnect the tool from the air supply before removing

or replacing the no-mar nosepiece. Failure to do so could

result in serious personal injury.

The no-mar nosepiece can be removed by pulling it down

and away from the nose. To replace the no-mar nosepiece

fit it into place over the workpiece contact and push up at

the back to reseat.

When requesting a replacement nosepiece, request part

number 089041015059.

ADJUSTING THE EXHAUST

See Figure 3, page 13.

The adjustable exhaust on the end cap of the tool allows the

operator to direct the exhaust according to operator prefer-

ence. To adjust, turn the exhaust cap until the exhaust blows

in the desired direction.

WARNING:

Disconnect the tool from the air supply before leaving the

work area, moving the tool to another location, or handing

the tool to another person. Failure to do so could result

in serious personal injury.

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Ryobi YG125CS Manuel d'utilisation et d'entretien Page 7

Commentaires sur ces manuels