8 — English
CONNECTING THE TOOL TO AN AIR SUPPLY
See Figure 4, page 13.
DANGER:
Do not use oxygen, combustible gases or bottled gases
as a power source for this tool. The tool will explode and
cause death or serious injury.
This tool is designed to operate on clean, dry compressed
air at regulated pressures between 70 and 120 psi. The cor-
rect air pressure is the lowest pressure that will do the job.
NOTE: Air pressure that is higher than 120 psi may damage
the tool.
The tool must have an air fitting that allows all pressure
to discharge from the tool when the air hose connector is
disconnected.
WARNING:
Always use an air fitting that discharges all the com-
pressed air in the tool at the time the air fitting and air
hose connector is disconnected. Using an air fitting that
does not discharge the compressed air could cause un-
intended operation and serious personal injury.
WARNING:
Do not climb rigging or scaffolding while carrying a tool
that is connected to an air hose. Doing so could result in
serious personal injury.
Connect the tool to the air supply with a 1/4 in. female quick
connector.
LOADING THE TOOL WITH STAPLES
See Figure 5, page 13.
Connect the tool to the air supply.
WARNING:
The tool’s driving mechanism may cycle when the tool
is first connected to the air supply. Always connect the
tool to the air supply before loading staples to prevent
injury from unintended cycling. Always make sure the
tool’s magazine is empty at the beginning of each work
session, before connecting to an air supply.
WARNING:
Keep the tool pointed away from yourself and others
when loading staples. Failure to do so could result in
possible serious personal injury.
WARNING:
Use only the staples recommended for use with this tool.
The use of any other staples can result in tool malfunction,
leading to serious injuries.
WARNING:
Never load staples with the workpiece contact or trig-
ger activated. Doing so could result in possible serious
personal injury.
Push the magazine latch to release and open the magazine.
With the nose of the tool pointed away from you, insert a
strip of staples into the magazine. Staples must always
be inserted with the points down, fitting over the staple
track.
To close the magazine, push it forward until the latch
clicks into place.
Make sure the magazine is securely locked into place
before driving a staple.
DRIVING A FASTENER
See Figure 6, page 14.
WARNING:
Never wedge or hold back the workpiece contact mecha-
nism during operation of the tool. Doing so could result
in possible serious injury.
SINGLE SEQUENTIAL ACTUATION
Single sequential actuation provides accurate fastener
placement.
Connect the tool to the air supply.
Grip the tool firmly to maintain control. Position the nose
of the tool onto the work surface.
Push the tool against the work surface to depress the
workpiece contact.
Pull the trigger to drive a fastener.
Allow the tool to recoil away from the work surface as the
fastener is driven.
OPERATION
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels