Ryobi C120D Manuel d'utilisateur télécharger pdf (Page 6)

6 − English

OPERATION

WARNING:

Do not allow familiarity with products to make you

careless. Remember that a careless fraction of a second

is sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes resulting in possible

serious injury.

WARNING:

Do not use any attachments or accessories not

recommended by the manufacturer of this product. The

use of attachments or accessories not recommended

can result in serious personal injury.

APPLICATIONS

You may use this product for the following purposes:

Charging compatible Ryobi 12 Volt battery packs

CAUTION:

If at any point during the charging process none of the

LEDs are lit, remove the battery pack from the charger

to avoid damaging the product. DO NOT insert another

battery. Return the charger and battery to your nearest

service center for service or replacement.

CAUTION:

Charge in a well ventilated area. Do not block charger

vents. Keep them clear to allow proper ventilation.

CHARGING

See Figure 2, page 8.

Battery packs are shipped in a low charge condition to

prevent possible problems. Therefore, you should charge

them before first use.

If the charger does not charge the battery pack under normal

circumstances, return both the battery pack and charger to

your nearest repair center for electrical check.

 Make sure the power supply is normal household voltage,

120 volts, AC only, 60 Hz.

Connect the charger to a power supply.

Attach the battery pack to the charger by aligning the

raised ribs on the battery pack with the grooves in the

charger, then slide the battery pack onto the charger.

 Press down on the battery pack to be sure contacts on

the battery pack engage properly with contacts in the

charger. Latches should snap into place to ensure charger

is correctly connected.

Do not place the charger in an area of extreme heat or

cold. It will work best at normal room temperature.

NOTE: The charger and battery pack should be placed

in a location where the temperature is more than 50°F

but less than 96°F.

The battery pack may become slightly warm to the touch

while charging. This is normal and does not indicate a

problem.

When the battery pack is fully charged, remove it from

the charger.

To remove the battery pack from the charger, depress

the latches on each side of the battery pack and pull up.

CHARGING A HOT BATTERY PACK

When using a tool continuously, the battery pack may be-

come hot. A hot battery pack may be placed directly onto

the charger port but charging will not begin until the battery

temperature cools to within acceptable temperature range.

When a hot battery pack is placed on the charger, the red

LED will begin flashing and the green LED will be off. When

the battery pack cools to approximately 120°F (40°C), the

charger will automatically begin charging.

CHARGING A COLD BATTERY PACK

A cold battery pack may be placed directly onto the charger

port but charging will not begin until the battery temperature

warms to within acceptable temperature range. When a cold

battery pack is placed on the charger, the red LED will begin

flashing and the green LED will be off. When the battery

pack warms to approximately 32°F (0°C), the charger will

automatically begin charging.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi C120D Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires photo Ryobi C120D