Ryobi BD4600 Manuel de l'opérateur télécharger pdf (Page 12)

4 x36

Fig. 6

Fig. 8

ASSEMBLY

INSTALLING SANDING DISC AND DISC

GUARD

See Figure 6.

 Unplug the belt/disc sander.

 Remove the backing from the sanding disc.

 Align perimeter of sanding disc with plate and press firmly

into position.

 Position disc guard against the lower one-third of the

disc, aligning holes as shown in figure 6.

 Using the two phillips head screws, securely tighten the

disc guard into place.

INSTALLING/REPLACING SANDING BELT

See Figure 7.

On the smooth side of the sanding belt, there is a directional

arrow. The sanding belt must run in the direction of the

arrow.

 Unplug the belt/disc sander.

 Pull the belt tension lever toward you to release belt

tension.

 Place the sanding belt over the drive roller and idler roller

with the directional arrows running counterclockwise. Be

sure the sanding belt is centered on both drums.

 Push the belt tension lever back into place to apply the

belt tension.

NOTE: The belt tension lever is spring loaded; use

extreme caution when pushing the tension lever back

into place to avoid personal injury.

MOUNTING THE WORKTABLE FOR USE WITH

THE DISC SANDER

See Figure 8.

 Unplug the belt/disc sander.

 Insert the index pin into the hole as shown in figure 8.

 Position the worktable no farther than 1/16 in. from the

sanding surface.

 Using a hex key, tighten the hex set screw securely.

MOUNTING THE WORKTABLE FOR USE WITH

THE BELT SANDER

See Figure 9.

 Unplug the belt/disc sander.

 Insert the index pin into the hole as shown in figure 9.

 Position the worktable no farther than 1/16 in. from the

sanding surface.

 Using a hex key, tighten the hex set screw securely.

CAUTION:

To avoid trapping the workpiece or your fingers between

the table and sanding surface, the table edge should

NEVER be further from the sanding surface than 1/16 in.

DISC GUARD

SANDING BELT

WORKTABLE

Fig. 7

WORKTABLE

DIRECTIONAL

ARROW

SANDING DISC

Fig. 9

PHILLIPS HEAD

SCREWS

HEX SET

SCREW

HEX SET

SCREW

DRIVE

ROLLER

IDLE

ROLLER

BELT TENSION

LEVER

INDEX

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire

Ryobi BD4600 Manuel de l'opérateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Ponceuses électriques Ryobi BD4600