Ryobi 7-1/4 in Compound Miter Saw TS1141 Manuel d'utilisateur télécharger pdf (Page 16)

ASSEMBLY

DUST BAG

See Figure 12.

A dust bag is provided for use on this miter saw. It fits over

the exhaust port on the upper blade guard. To install, squeeze

the two metal clips to open the mouth of the bag and slide

it on the exhaust port. Release the clips. The metal ring in

the bag should lock in between the grooves on the exhaust

port. To remove the dust bag for emptying, simply reverse

the above procedure.

WORK CLAMP

See Figure 13.

The work clamp provides greater control by clamping the

workpiece to the fence or the table. It also prevents the

workpiece from creeping toward the saw blade. This is very

helpful when cutting compound miters.

Depending on the cutting operation and the size of the

workpiece, it may be necessary to use a C-clamp instead

of the work clamp to secure the workpiece prior to making

the cut.

WARNING:

In some operations, the work clamp assembly may

interfere with the operation of the blade guard assembly.

Always make sure there is no interference with the blade

guard prior to beginning any cutting operation to reduce

the risk of serious personal injury.

To install the work clamp:

Place the shaft of the work clamp in either hole on the

saw table base.

 Rotate the knob on the work clamp to move it in or out

as needed.

INSTALLING BATTERIES IN LASER

See Figure 14.

Remove screw from battery compartment cover using

the Phillips end of the supplied blade wrench. Remove

cover and set aside.

 Install two AAA batteries according to polarity indicators

inside the battery compartment.

 Replace the battery compartment cover. Reinstall screw

and tighten securely.

Fig. 13

base

work

cLaMp

dust

bag

Fig. 12

Fig. 14

batteries

coMpartMent

cover

screw

exhaust

port

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi 7-1/4 in Compound Miter Saw TS1141 Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi 7-1/4 in Compound Miter Saw TS1141