Ryobi 7-1/4 in Compound Miter Saw TS1141 Manuel d'utilisateur Page 19

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 18
19
ASSEMBLY
Fig. 18
view of Miter tabLe square with fence
Miter
Lock
Lever
Miter
tabLe
throat pLate
square
NOTE:
Many of the illustrations in this manual show only
portions of the compound miter saw. This is intentional so
that we can clearly show points being made in the illustra-
tions. Never operate the saw without all guards securely
in place and in good operating condition.
SQUARING THE MITER TABLE TO THE
FENCE
See Figures 18 - 21.
Unplug the saw.
Push down on the saw arm and pull out the lock pin to
release the saw arm.
Raise the saw arm.
Lift the miter lock lever.
Rotate the miter table until the pointer aligns with zero
on the miter scale.
Push the miter lock lever down to lock the miter table.
Lay a square flat on the miter table. Place one leg of the
square against the fence. Place the other leg of the square
beside the throat plate in the miter table. The edge of the
square and the throat plate in the miter table should be
parallel as shown in figure 18.
If the edge of the square and the throat plate in the
miter table are not parallel as shown in figures 19
and 20, adjustments are needed.
Using the blade wrench provided, loosen the socket head
screws securing the fence. Adjust the fence left or right
until the square and throat plate are parallel.
Retighten the screws securely and recheck the fence-to-
table alignment.
square
Fig. 19
view of Miter tabLe not square with
fence, adJustMents are required
throat pLate
Miter
tabLe
square
Fig. 20
view of Miter tabLe not square with
fence, adJustMents are required
Miter
tabLe
throat pLate
Miter
fence
Miter
fence
Miter
fence
1
2
3
4
5
6
7
1
2
3
4
5
6
7
pointer
Vue de la page 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Commentaires sur ces manuels

Pas de commentaire