Ryobi BTS211 Manuel d'utilisateur télécharger pdf (Page 18)

Fig. 12

SMALL

BLADE

WRENCH

LARGE

BLADE WRENCH

TO CHECK SAW BLADE INSTALLATION

See Figure 12.

CAUTION:

To work properly, the saw blade teeth must point down

toward the front of the saw. Failure to do so could cause

damage to the saw blade, the saw, or the workpiece.

NOTE: Arbor shaft has left hand threads.

 Lower the saw blade and remove the throat plate.

 Make sure the bevel locking lever is securely pushed to

the left. Raise the saw blade to its full height by turning

the height/bevel adjusting handwheel clockwise.

To loosen the blade:

 Using the smaller blade wrench, place the ﬂat open end

on the ﬂats on the arbor shaft.

 Insert the closed end of the larger blade wrench over

the hex nut. Holding both wrenches ﬁrmly, pull the larger

wrench forward to the front of the machine.

To tighten the blade:

 Using the smaller blade wrench, place the ﬂat open end

into the ﬂats on the arbor shaft.

 Insert the closed end of the larger blade wrench over the

hex nut. Holding both wrenches ﬁrmly, push the larger

wrench to the back of the machine. Make sure the blade

nut is securely tightened. Do not overtighten.

 Reinstall the throat plate.

 Check all clearances for free blade rotation.

TO INSTALL MITER FENCE

See Figure 13.

 Remove the miter fence from the miter fence storage on

the side of the saw cabinet.

 To install the miter fence to the sliding miter table, loosen

the adjusting clamp knob so the bolt has enough clear-

ance to slide into the table slot.

NOTE: If the miter fence holder is not installed, slide the

tabs into the grooves in the miter fence.

 Mount the miter fence to the miter table by installing the

locator pin (below the miter fence) into holes “A” or “B”.

At the same time, place the attachment bolt in the slot.

 Properly adjust the miter indicator to the scale on the end

of the fence opposite the locator pin.

 Retighten the adjusting clamp knob.

ATTACHMENT

BOLT

ADJUSTING

CLAMP KNOB

TAB

MITER

FENCE

HOLDER

HOLE “A”

HOLE “B”

TABLE

SLOT

MITER

INDICATOR

MITER

FENCE

Fig. 13

ASSEMBLY

LOCATOR

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 41 42

Commentaires sur ces manuels

Pas de commentaire

Ryobi BTS211 Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi BTS211