21
Fig. 17
3/8 in. DIAMETER
1/8 in.
1/4 in.
3/4 in.
3-5/8 in.
30°
45°
6 in.
8 in.
10 in.
12 in.
18 in.
OPERATION
FEATHERBOARD
A featherboard is a device used to help control the
workpiece by guiding it securely against the table or fence.
Featherboards are especially useful when ripping small
workpieces and for completing non-through cuts. The end
is angled with a number of short kerfs to give a friction hold
on the workpiece and locked in place on the table with a
C-clamp. Test to ensure it can resist kickback.
WARNING:
Place the featherboard against the uncut portion of the
workpiece to avoid kickback that could cause serious
personal injury.
HOW TO MAKE A FEATHERBOARD
See Figure 17.
The featherboard is an excellent project for the saw.
Select a solid piece of lumber approximately 3/4 in. thick,
3-5/8 in. wide and 18 in. long. Mark the center of the width
on one end of the stock. Miter one-half of the width to 30°
and miter the other half of the same end to 45° (see page
30 for information on miter cuts). Mark the board from the
point at 6 in., 8 in., 10 in., and 12 in. Drill a 3/8 in. hole at the
8 in., 10 in., and 12 in. marks.
Prepare the saw for ripping as discussed on page 29. Set
the rip fence to allow approximately a 1/4 in. “finger” to be
cut in the stock. Feed the stock only to the mark previously
made at 6 in. Turn the saw OFF and allow the blade to com-
pletely stop rotating before removing the stock. Reset the
rip fence and cut spaced rips into the workpiece to allow
approximately 1/4 in. fingers and 1/8 in. spaces between
the fingers.
HOW TO MOUNT A FEATHERBOARD
See Figure 18.
Remove the adjusting clamp knob, bolt, and washer from
the miter fence holder. Place the bolt through one of the
holes in the featherboard. Positioning the featherboard will
depend on the placement of the bolt and the position of the
sliding miter table on the rails. Place the washer on the bolt
and attach the adjusting clamp knob, loosely. Position the
featherboard with the hex head of the bolt in the miter table
slot but do not tighten. Completely lower the saw blade.
Position the rip fence to the desired adjustment for the cut
to be performed and lock. Place the workpiece against the
fence and over the saw blade area. Adjust the featherboard
to apply resistance to the workpiece just forward of the
blade. Securely tighten the adjusting clamp knob to secure
the featherboard in place. Attach a C-clamp to further secure
the featherboard to the edge of the sliding miter table.
WARNING:
Do not locate the featherboard to the rear of the
workpiece. If positioned improperly, kickback can result
from the featherboard pinching the workpiece and bind-
ing the blade in the saw kerf. Failure to heed this warning
can result in serious personal injury.
PUSH BLOCK
Fig. 18
FEATHERBOARD
PUSH
STICK
BEVEL LOCKING
LEVER
1-1/16 in.
(42 pages)
(42 pages)
(42 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels