Ryobi RTS21 Manuel d'utilisateur télécharger pdf (Page 28)

OPERATION

HEELING (PARALLELING) THE BLADE TO THE

MITER GAUGE GROOVE

See Figures 34 - 35.

WARNING:

The blade must be parallel to the miter gauge groove so

the wood does not bind resulting in kickback. Failure to

do so could result in serious personal injury.

Do not loosen any bolts for this adjustment until you have

checked with a square and made test cuts to be sure adjust-

ments are necessary. Once the bolts are loosened, these

items must be reset.

 Unplug the saw.

 Remove the blade guard and anti-kickback pawls.

 Mark beside one of the blade teeth at the front of the blade.

Place a framing square even with the front of the saw

table and the side of the saw blade as shown in figure 34.

 Turn the blade so the marked tooth is at the back.

 Move the combination square to the rear and again

measure the distance. If the distances are the same,

the blade is square.

If the distances are different:

 Extend the extension table, see page 27.

 Place riving knife in “down” position.

 Loosen the locking bolts by turning towards the left.

NOTE: The bolts are located above the height/bevel

adjusting handwheel and under the saw table in the

front of the saw.

 Turn adjusting bolt left or right until the blade is square.

 Tighten the locking bolts. Check again for squareness

and continue to adjust if needed.

WARNING:

To reduce the risk of injury from kickback, align the rip

fence to the blade following any blade adjustments.

Always make sure the rip fence is parallel to the blade

before beginning any operation.

COMBINATION

SQUARE

COMBINATION

SQUARE

Fig. 35

Fig. 34

LOCKING

BOLTS (2)

RIGHT MITER

GAUGE GROOVE

SAW BLADE OUT OF ALIGNMENT

ADJUSTING

BOLT

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Ryobi RTS21 Manuel d'utilisateur Page 28

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi RTS21