Ryobi BGH6110SB Manuel de l'opérateur télécharger pdf (Page 9)

9 — English

ASSEMBLY

Carefully check the workbench after mounting to make sure

that no movement can occur during use. If any tipping, slid-

ing, or walking is noted, secure the workbench to the floor

before operating.

MOUNTING SPARK SHIELD ASSEMBLY

See Figure 6, page 12.

 Attach the spark shield assembly and bracket to the wheel

guard using a clamp bracket, washer, and hex head bolt.

 Tighten bolt securely.

 Repeat above steps for the other side.

MOUNTING SPARK DEFLECTOR

See Figure 6, page 12.

 Using the two phillips head screws, washers, and lock

washers, attach the spark deflector to the top of the wheel

guard.

 Adjust the spark deflectors to within 1/16 in. (1.6 mm) of

the grinding wheel. Tighten screws securely.

MOUNTING WORK REST

See Figure 7, page 13.

 Unscrew and remove the carriage bolt from the work rest

knob.

 Attach the work rest to the inside of the wheel guard as

shown.

NOTE: As the diameter of the wheel decreases with use,

adjust the distance between the wheel and the work rest

to maintain 1/16 in. or less separation.

 Tighten knob securely.

WARNING:

Do not allow familiarity with tools to make you care-

less. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes, resulting in possible

serious injury.

WARNING:

Do not use any attachments or accessories not

recommended by the manufacturer of this tool. The use

of attachments or accessories not recommended can

result in serious personal injury.

NOTICE:

Excessive pressure on a cold wheel may cause the wheel

to crack.

NOTICE:

Never sharpen or grind anything made of aluminum,

brass, or copper.

WARNING:

Do not use wheels rated less than the speed of this tool.

Failure to heed this warning could result in personal injury.

APPLICATIONS

This product has been designed only for the purposes listed

below:

 Sharpening drill bits

 Sharpening lawn mower blades

 Sharpening chisels and flat screwdrivers

BASIC OPERATION

To be efficient and work as designed, your tools should be

kept sharp. Dull tools can and will cause accidents.

Bench grinders are ideal for sharpening tools such as chis-

els, planer blades, scissors, etc., and for removing rust or

corrosion. Grinders remove material rapidly so pressure is

the key to efficient grinding.

The proper way to sharpen a tool and avoid overheating is:

 Keep the object in constant motion, moving it at an even

pace.

 Never force a tool against the grinding wheel.

 Keep the tool cool by using a pan of water.

 The grinding wheel should rotate “into” the object being

sharpened.

NOTE: Excessive pressure may damage the tool, cause the

motor to overheat, and prematurely wear down the grinding

wheel.

ON/OFF SWITCH

See Figure 8, page 13.

The bench grinder features a front access On/Off switch for

convenience and safety.

OPERATION

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Ryobi BGH6110SB Manuel de l'opérateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Meuleuses droites Ryobi BGH6110SB