Ryobi HD1800M Manuel d'utilisateur télécharger pdf (Page 7)

SPECIFICATIONS

UNPACKING

INSTRUCTIONS

Your hammer drill has been shipped completely assembled.

■ Carefully remove the tool and accessories from the

box.

■ Make sure that all items listed in the packing list are

included.

■ Inspect the tool carefully to make sure no breakage or

damage occurred during shipping.

■ Do not discard the packing material until you have

carefully inspected and satisfactorily operated the tool.

■ If any parts are damaged or missing, please call

1-800-525-2579 for assistance.

APPLICATIONS

You may use the hammer drill for the purposes listed below:

■ Hammer drilling in concrete, brick, or other masonry.

■ Drilling in wood.

■ Drilling in ceramics, plastics, fiberglass, and laminates.

■ Drilling in both soft and hard metals.

■ Driving screws with screwdriver bits, using driving accessories.

■ Mixing paint.

PACKING LIST

Hammer Drill with Auxiliary Handle Assembly

Battery Pack (2)

Charger

Carrying Case

Operator’s Manual

WARNING:

If any parts are missing do not operate your tool until

the missing parts are replaced. Failure to do so could

result in possible serious personal injury.

WARNING:

The hammer drill should never be connected to a

power supply when you are assembling parts, making

adjustments, cleaning, performing maintenance, or

when the tool is not in use. Disconnecting the tool will

prevent accidental starting that could cause serious

injury.

HAMMER DRILL

Chuck ...................................................................................................................................................................... 1/2 in.

Maximum Torque ...............................................................................................................................................350 in.lbs

Switch....................................................................................................................................................... Variable Speed

Clutch ............................................................................................................................................................. 24 positions

Motor ................................................................................................................................................................18 Volt DC

Hammer Speed ..................................................................................... Low (0 - 5,200 BPM*) & High (0 - 18,200 BPM*)

No Load Speed .................................................................................................. Low (0 - 400/min) & High (0 - 1400/min)

CHARGER ASSEMBLY

Charger Input ........................................................................................................................... 120 Volts, 60 Hz, AC only

Charger Voltage ..................................................................................................................................................... 18 Volt

Charge Rate ........................................................................................................................................................... 1 Hour

* Blows Per Minute