Ryobi 310r Manuel d'utilisateur télécharger pdf (Page 17)

ENGINE

Manufacturer ..........................Ryobi Outdoor Products,

Inc.

Type ..........................................2-Cycle, Air-Cooled

Displacement............................31 cc (1.9 cu. in)

Bore ..........................................1.37 in (34.79 mm)

Stroke ......................................1.25 in (31.75 mm)

Operating RPM ........................7200-7500

Ignition ......................................Electronic Ignition

Lubrication................................Fuel/Oil Mix

Carburetor ................................Diaphragm, All Position

Ignition Switch ..........................Push Button

Starter ......................................Auto Rewind

Muffler ......................................Baffled With Guard

Clutch ......................................None

Throttle......................................Manual Spring Return

Bearings....................................Needle & Ball

Crankshaft ................................Cantilevered

Connecting Rod........................Steel

Fuel Tank ..................................Clear Sight

Fuel Tank Capacity ..................18 fl. oz (0.51 L)

BLOWER

Max. Blower Velocity ................150 mph (241.4 kmh)

Max. Blower Volume ................324 cfm (9.18 cmm)

Operating Weight......................12 lbs (5.22 kg)

BLOWER / VACUUM

Vacuum Bag Capacity ..............1.4 bushels (0.066m

)

SPECIFICATIONS

WARNING

Always turn off your unit before you clean

or perform any maintenance on it.

Cleaning

Use a small brush to clean off the outside of the unit. Do

not use strong detergents on plastic housing or handle.

They can be damaged by household cleaners that contain

aromatic oils such as pine and lemon, and by solvents

such as kerosene.

Storage

If the unit will be stored for an extended period of time,

use the following storage procedure.

1. Drain all fuel from the fuel tank. Make sure that the

fuel is drained into a container with the same 2-cycle

fuel mixture. Do not use fuel that has been stored for

more than 60 days. Dispose of the old fuel/oil mix in a

safe manner and use a fresh mix.

2. Start the engine and allow it to run until it stalls.

3. Allow the engine to cool. Remove the spark plug and

put approximately 1 ounce of any high quality motor

oil or 2-cycle oil into the cylinder. Pull the starter rope

slowly to distribute the oil. Reinstall the spark plug.

NOTE: Remove the spark plug and drain all of

the oil from the cylinder before attempt-

ing to start the unit after storage.

4. Thoroughly clean the unit and inspect it for any loose

or damaged parts. Repair or replace the damaged

parts and tighten any loose screws, nuts or bolts.

The unit is now ready for storage.

5. Store the unit in a dry, well-ventilated area.

CLEANING AND STORAGE

1 2 ... 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi 310r Manuel d'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs Ryobi 310r