Ryobi MS181 Manuel de l'opérateur télécharger pdf (Page 25)

Page 25

4 5

3 0

22.5

31.62

OPERATION

BEVEL CUT

See Figures 34 and 35.

A bevel cut is made by cutting across the grain of the

workpiece with the blade angled to the fence and

miter table. A bevel cut is made with the miter table

set at the zero degree position and the blade set at an

angle between 0° and 45°.

TO BEVEL CUT WITH YOUR MITER SAW:

■ Pull out the lock pin and lift saw arm to its full

height.

■ Lift the miter table clamp.

■ Rotate the miter table until the pointer aligns with

zero on the miter scale.

■ Push the miter table clamp back down.

Note: You can quickly locate zero on the scale.

The miter table can be seated in one of the built-in

detent stops, located in the miter table frame.

WARNING:

To avoid serious personal injury, always push the

miter table clamp back down before making a cut.

Failure to do so could result in movement of the

miter table while making a cut.

■ Loosen the bevel lock knob and move the saw

arm to the left to the desired bevel angle.

■ Bevel angles can be set from 0° to 45°.

■ Align the indicator point with the desired angle.

■ Once the saw arm has been set at the desired

angle, securely tighten the bevel lock knob.

■ Place the workpiece flat on the miter table with

one edge securely against the fence. If the board

is warped, place the convex side against the

fence. If the concave edge of a board is placed

against the fence, the board could collapse on the

Fig. 34

MOUNTING

BRACKET

SCALE

INDICATOR

POINT

BEVEL

LOCK KNOB

Fig. 35

BEVEL CUT

C-CLAMP

blade at the end of the cut, jamming the blade.

See Figures 40 and 41.

■ When cutting long pieces of lumber or molding,

support the overhanging end(s) of the stock with a

roller stand or with a work surface level with the

saw table.

■ Align the cutting line on the workpiece with the

edge of saw blade.

■ Grasp the stock firmly with one hand and secure it

against the fence. Use the work clamp or a C-

clamp to secure the workpiece when possible.

See Figure 35.

WARNING:

To avoid serious personal injury, always keep your

hands outside the no hands zone; at least 3 in.

(8 cm) from blade. Never perform any cutting

operation freehand (without holding workpiece

against the fence). The blade could grab the

workpiece if it slips or twists.

■ Before turning on the saw, perform a dry run of

the cutting operation just to make sure that no

problems will occur when the cut is made.

■ Grasp the saw handle firmly, depress the lock-off

button, then squeeze the switch trigger. Allow

several seconds for the blade to reach maximum

speed.

■ Slowly lower the blade into and through the

workpiece.

See Figure 35.

■ Release the switch trigger and allow the saw

blade to stop rotating before raising the blade out

of workpiece. Wait until the electric brake stops

blade from turning before removing the workpiece

from miter table.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi MS181 Manuel de l'opérateur Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Ryobi MS181