Ryobi P360 Manuel d'utilisation et d'entretien télécharger pdf (Page 10)

10 — English

OPERATION

Contact actuation mode:

Contact actuation allows very fast repetitive fastener place-

ment.

 Remove battery pack from the tool.

Slide the selector to position ( ).

Reinstall the battery and reactivate the tool.

Grip the tool firmly to maintain control.

Squeeze and hold the trigger. Push the tool against the

work surface to depress the workpiece contact and drive

a staple.

Lift the tool from the workpiece to drive the next staple.

NOTE: Hold trigger until drive cycle is complete.

Always remove your finger from the trigger when the

desired number of fasteners has been driven.

NOTE: In Contact Actuation Mode, the tool may also be

operated by depressing the workpiece contact against the

surface and squeezing the trigger.

DRY-FIRE LOCKOUT

The dry-fire lockout feature keeps the tool from operating

when fasteners are low in the magazine.

The low staple indicator window in the magazine shows

how many staples remain in the tool.

When the magazine has 0-5 staples remaining, the dry-fire

lockout feature will not allow continued operation.

To resume operation, reload the tool with staples.

CONSTRUCTION RULER

A construction ruler located along the left side of the maga-

zine allows the operator to make quick measurements while

working.

LED WORKLIGHTS/DIAGNOSTIC FEEDBACK

See Figure 10, page 13.

The LED Worklights provide feedback to indicate whether

the battery pack is charged sufficiently and/or if the tool is

functioning properly.

To turn on the worklights, press the LED worklight grip switch

while firmly holding tool in normal operating position.

If worklights are flashing, install fully charged battery. If

lights continue to flash, see Troubleshooting section for

more information.

REMOVING A JAMMED STAPLE

See Figure 11, page 13.

WARNING:

Remove the battery pack before removing staples or

clearing a jammed staple. Failure to do so could result

in serious personal injury.

 Remove the battery pack from the tool.

 Open the magazine and remove staples.

Insert a flat blade screwdriver into the driving mechanism

and push the driver mechanism back, freeing the jam.

Remove the bent staple.

Reinsert staples and close the magazine.

Reinstall the battery and reactivate the tool.

NOTE: Driving too deeply into the material, excess debris,

or jammed fasteners may lead to a driver blade being stuck

at its bottom position.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Ryobi P360 Manuel d'utilisation et d'entretien Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Pistolet à clous Ryobi P360