Ryobi P360 Manuel d'utilisation et d'entretien télécharger pdf (Page 9)

9 — English

 Push the magazine cover closed. Make sure it securely

snaps into place.

 Reinstall battery, and reactivate the tool by pressing the

worklight grip switch.

REMOVING STAPLES FROM THE TOOL

 Remove the battery pack.

Depress the magazine release button.

 Remove staples and close the magazine.

SETTING THE AIR PRESSURE

See Figure 6, page 13.

The amount of air pressure required will depend on the size

of the fastener and the workpiece material.

Begin testing the depth of drive by driving a test fastener into

the same type of workpiece material used for the actual job.

 Remove battery pack from the tool, if installed.

 Turn air pressure dial clockwise to increase air pressure

or counterclockwise for decreased pressure.

It may be possible to achieve the desired depth with air

pressure adjustments alone. If finer adjustments are needed,

use the depth of drive adjustment on the tool.

NOTE: Under some conditions, the unit may not deliver a

fastener when the air pressure dial is turned to the MAXI-

MUM pressure setting. The user may need to decrease the

pressure setting for desired operation.

ADJUSTING DEPTH OF DRIVE

See Figure 7, page 13.

The driving depth of the fastener may be adjusted beyond

air pressure. It is advisable to test the depth on a scrap

workpiece to determine the required depth for the application.

To determine depth of drive, first adjust the air pressure and

drive a test fastener. To achieve the desired depth, use the

depth of drive adjustment on the tool. Harder materials and

longer fasteners will require more force to drive the staple.

 Remove battery pack from the tool, if installed.

Turn the depth of drive adjustment left or right to change

the driving depth.

 Reinstall battery and reactivate the tool by pressing the

worklight grip switch.

Drive a test staple after each adjustment until the desired

depth is set.

NOTE: Set depth of drive at the shallowest depth that

will meet your needs.

DRIVING STAPLES

See Figures 8 - 9, page 13.

WARNING:

Never wedge or hold back the workpiece contact mecha-

nism during operation of the tool. Doing so could result

in possible serious injury.

The mode selector lets the operator choose between Single

Sequential Actuation for precise fastener placement and

Contact Actuation for higher productivity.

The tool will drive a fastener each time the trigger is depressed,

as long as the workpiece contact is depressed.

Single sequential actuation mode:

Single sequential actuation provides the most accurate

fastener placement.

 Remove battery pack from the tool.

Slide the selector to position ( ).

WARNING:

The stapler will not function properly if the selec-

tor is not securely seated in either position ( ) or

( ). Always assure the selector is seated properly to

avoid an unexpected fastener discharge and possible

serious personal injury.

Reinstall the battery and reactivate the tool.

Grip the tool firmly to maintain control. Position the nose

of the tool onto the work surface.

Push the tool against the work surface to depress the

workpiece contact.

Squeeze the trigger to drive a fastener.

NOTE: Hold trigger until drive cycle is complete.

Always remove your finger from the trigger when the

desired number of fasteners has been driven.

OPERATION

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Ryobi P360 Manuel d'utilisation et d'entretien Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Pistolet à clous Ryobi P360