Ryobi BTS10 Manuel d'utilisateur

RYOBIOPERATOR’S MANUAL 10 in. (254 mm) TABLE SAW Model BTS10THANK YOU FOR BUYING A RYOBI TABLE SAW.Your new Table Saw has been engineered and manufact

ASSEMBLYA WARNING:Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and

ASSEMBLYAttach blade guard assembly to support bracket with M6 X 19 mm carriage bolt. Secure with a 1/4" fiat washer, external too

GENERAL INFORMATIONA WARNING:Yourtable saw has a precision built electric motor. It should only be connected to a power supply that is 120 v

ADJUSTMENTSCALIBRATING AND ADJUSTING YOUR SAWA WARNING:Before performing any adjustments or calibrations, make sure the table saw is unplugged f

ADJUSTMENTSReset the Bevel Indicator to 90° by loosening the screw holding the indicator. Line up the red line on the indicator wit

OPERATIONstraight Cross CutCut made across the grain.Miter Cross CutCut made with the workpiece at an angle (other than 90°) relative to the

OPERATIONThis section deals with the proper procedures for makingthese seven basic cuts.CUTTING TIPS• The kerf (the cut made by the blade in the wood

OPERATION5. Position the workpiece flat on the table with the edge flush against the miter gauge. Let the blade build up to full speed b

OPERATIONTO MAKE A BEVEL RIP CUTIt is recommended that you place the piece to be saved on the right side of the blade and that you make a test cu

OPERATION1. Remove the wing nut and carriage bolt holding the blade guard assembly to the blade guard support bracket. See Figure 24. Remove the blad

TABLE OF CONTENTSTable of Contents...

OPERATIONSAFETY CONSIDERATIONS AVOIDING KICKBACKKickback can occur when the blade stalls or binds, kicking the workpiece back toward the

MAINTENANCEGENERAL MAINTENANCEA WARNING:Always begin any maintenance procedure by disconnecting the saw from the power supply to avoid ri

TROUBLE SHOOTING-ProblemPossible CauseSolutionExcess Vibration.1. Blade is out of balance.2. Blade is warped or damaged.3. Saw is not mounted secur

NOTESPage 23

SyOSI OPERATOR’S MANUAL IX IW0I. ^ Q ¡1^ ^254 mm) TABLE SAWModel BTS10EXTENSION CORD CAUTIONWhen using a power tool at a considerable distance from a

RULES FOR SAFE OPERATIONThe purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the e

RULES FOR SAFE OPERATIONREAD AND UNDERSTAND ALL INSTRUCTIONS1. Know your power tool. Read and understand the operator's manual carefully.

RULES FOR SAFE OPERATION29. Do not use tool if switch does not turn it on and off.Have defective switches replaced by a qualified service technician

SPECIFIC SAFETY RULES FOR THE BTS10 TABLE SAWNever perform any operation freehand, which means using only your hands to support or guide the workpi

GLOSSARY OF WOODWORKING TERMSHeelMisalignment of the blade.KerfThe amount of material removed by the blade in a throughout, or the slot produced by t

UNPACKING YOUR TABLE SAW AND CHECKING CONTENTSYour Mode! BTS10 Table Saw is shipped complete in one carton and includes rip fence, miter

FEATURESKnow Your Table SawYour saw is designed to perform as a versatile, accurate, precision wood cutting tool that Is easy to oper