15
ANGLE CUTTING (BEVEL CUTTING)
See Figures 13 and 14.
Bevel cutting angles may be adjusted from 0° to 45° right
or left. Angles for cuts from 0° to 45° in 15° increments are
marked on a scale on both the left and right side of the base.
An arrow under the motor assembly provides an indicator at
each of the above mentioned 15° increments. A protractor
is recommended when accurate cuts are required.
n Unlock the base by moving the base locking lever for-
ward.
�n Align the mark, on the base, of the desired angle with the
indication arrow located on the housing.
�n Once the desired angle is reached, tighten the base locking
lever by moving the base locking lever under the motor
assembly.
BASE
LOCKING
LEVER
OPERATION
Fig. 13
Fig. 14
Commentaires sur ces manuels