Ryobi JS550L Manuel d'utilisateur télécharger pdf (Page 18)

ADJUSTMENTS

LASER GUIDE ADJUSTMENT

See Figure 20.

NOTE: Draw a pencil line on a scrap workpiece parallel to

the long edge of the base as a straight line guide to aid in

the adjusting process.

n Unplug the jig saw.

WARNING:

Failure to unplug your saw could result in accidental start-

ing causing possible serious personal injury.

n If the laser guide is on the right side of the line, turn the

laser adjustment screw counter clockwise one half of a

turn.

n If the laser guide is on the left side of the line, turn the

laser adjustment screw clockwise one half of a turn.

n Plug saw into power supply.

n Pull the switch trigger just enough to light the laser guide

to check for position.

n Repeat above steps if necessary.

Fig. 20

LASER LINE AT

RIGHT SIDE

CUT LINE

LASER LINE AT

LEFT SIDE

LASER

ADJUSTMENT

SCREW

1 2 ... 13 14 15 16 17 18 19 20

Pas de commentaire

Ryobi JS550L Manuel d'utilisateur Page 18