Ryobi TS1552DXL Manuel d'utilisateur télécharger pdf (Page 29)

OPERATION

WRONG

WARNING:

To avoid a kickback and to avoid serious personal injury,

never position the concave edge of bowed or warped

material against the fence.

CLAMPING WIDE WORKPIECES

See Figure 42.

When cutting wide workpieces, such as 2 in. x 6 in., boards

should be clamped with a C-clamp as shown in figure 42.

Bevel

Angle Type of Cut

Setting

Left side, inside corner

1. Top edge of molding against fence

2. Miter table set right 31.62

3. Save left end of cut

Right side, inside corner

1. Bottom edge of molding against fence

2. Miter table set left 31.62

3. Save left end of cut

Left side, outside corner

1. Bottom edge of molding against fence

2. Miter table set left 31.62

3. Save right end of cut

Right side, outside corner

1. Top edge of molding against fence

2. Miter table set right 31.62

3. Save right end of cut

33.85

Fig. 42

CUTTING WARPED MATERIAL

See Figures 40 - 41.

When cutting warped material, always make sure it is posi-

tioned on the miter table with the convex side against the

fence as shown in figure 40.

If the warped material is positioned the wrong way as shown

in figure 41, it will pinch the blade near the completion of

the cut.

Fig. 40

RIGHT

WIDE

BOARD

Fig. 41

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

Commentaires sur ces manuels

Pas de commentaire

Ryobi TS1552DXL Manuel d'utilisateur Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi TS1552DXL