Ryobi P421 Manuel d'utilisation et d'entretien télécharger pdf (Page 8)

8 — English

ASSEMBLY

OPERATION

WARNING:

Do not allow familiarity with this product to make you

careless. Remember that a careless fraction of a second

is sufficient to inflict serious injury.

WARNING:

Always remove battery pack from the tool when you are

assembling parts, making adjustments, cleaning, or when

not in use. Removing battery pack will prevent accidental

starting that could cause serious personal injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1, along with hearing protection.

Failure to do so could result in objects being thrown into

your eyes and other possible serious injuries.

WARNING:

Do not use any attachments or accessories not recom-

mended by the manufacturer of this product. The use of

attachments or accessories not recommended can result

in serious personal injury.

 Depress the spindle lock button and rotate the clamp nut

until the spindle locks.

NOTE: To prevent damage to the spindle or spindle lock,

always allow motor to come to a complete stop before

engaging spindle lock.

 Loosen and remove the clamp nut from the spindle. Do

not remove the disc flange.

 Make sure the flats on the bottom of the disc flange are

engaged with the flats on the spindle.

 Place the grinding wheel over the spindle.

WARNING:

Always install a grinding wheel with the depressed center

against the disc flange. Failure to do so will cause the

grinding wheel to crack when tightening the clamp nut.

This could result in serious personal injury because of

loose particles breaking off and being thrown from the

grinder. Do not overtighten.

 Thread the clamp nut on the spindle with the flat side of

the nut facing up.

 Fit the raised, small diameter portion of the clamp nut

into the hole in the wheel and finger tighten.

 Depress the spindle lock button and rotate the wheel

clockwise until the spindle locks in position.

 Tighten the clamp nut securely with the wrench provided.

Do not overtighten.

INSTALLING THE SIDE HANDLE

See Figure 2, page 12.

WARNING:

The side handle must always be used to help prevent

loss of control and possible serious injury.

The side handle can be installed on the top, left, or right side

of the grinder, depending on operator preference.

 Insertthesidehandleintothedesiredoperatingposition.

 Turn the side handle clockwise to securely tighten.

APPLICATIONS

You may use this product for the purpose listed below:

 Grinding metals

 Sanding wood or metal surfaces

WARNING:

Battery products are always in operating condition.

Therefore, the switch should always be locked when not

in use or carrying at your side.

INSTALLING/REMOVING BATTERY PACK

See Figure 3, page 12.

To install:

Insert the battery pack.

Make sure the latches on each side of the battery pack

snap in place and that battery pack is secured in the

product before beginning operation.

To remove:

 Depress the latches on each side of the battery pack.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi P421 Manuel d'utilisation et d'entretien Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi P421