Ryobi HD1800M Manuel d'utilisateur télécharger pdf (Page 11)

ADJUSTMENTS

ADJUSTING THE TORQUE

See Figure 5.

The hammer drill is equipped with an adjustable torque

clutch for driving different types of screws into different

materials. Adjust the torque as necessary. We recommend

that you use carbide-tipped bits and select hammer mode

when drilling in hard materials such as brick, tile, concrete,

etc.

Follow these steps to adjust the torque.

■ Identify the torque indicator settings located on the

front of the hammer drill.

■ Rotate the adjusting ring to the desired setting.

• 1 - 4 For driving small screws.

• 5 - 8 For driving screws into soft material.

• 9 - 12 For driving screws into soft and hard

materials.

• 13 - 16 For driving screws in hard wood.

• 17 - 20 For driving large screws.

• 21 - For heavy drilling.

• For hammer drilling.

CHANGING THE BIT ROTATION

See Figure 6.

The direction of the chuck is controlled by the rotation

selector located above the trigger switch.

Follow these steps to change the bit rotation.

■

For forward rotation

: Move the rotation selector to the

left.

■

For reverse rotation

: Move the rotation selector to the

right.

Note: The hammer drill will not run unless the

selector is pushed fully to the left or right.

CAUTION:

The hammer drill is not designed for reverse hammer-

ing. Failure to obey this caution may result in property

damage.

Fig. 5

Fig. 6

TO DECREASE

TORQUE

TO INCREASE

TORQUE

ADJUSTING RING

FORWARD / REVERSE

SELECTOR

CENTER POSITION

(LOCK)

REVERSE

FORWARD

DRILLING MODE

HAMMER MODE

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire

Ryobi HD1800M Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi HD1800M