Ryobi 155VP Manuel de l'opérateur télécharger pdf (Page 13)

MAINTENANCE AND REPAIR INSTRUCTIONS

Outer Spool

Spring

Inner Reel

PRESS TABS

Bump Head

Cover

WARNING: Battery tools do not have to be

plugged into an electrical outlet; therefore,

they are always in operating condition. To

prevent serious personal injury, take extra

precautions and care when performing

maintenance, service or for changing the

cutting attachment or other attachments.

WARNING: To prevent serious personal

injury, remove or disconnect the battery

before servicing, cleaning, changing add-on

attachments or removing material from the unit.

GENERAL RECOMMENDATIONS

The warranty on this unit does not cover items that have

been subjected to operator abuse or negligence. To

receive full value from the warranty, the operator must

maintain the unit as instructed in this operator’s manual.

BEFORE EACH USE CHECK FOR

DAMAGED/WORN PARTS

• Bump head — Replace bump head parts

that are bent, warped, cracked, or damaged in any

way.

AFTER EACH USE CLEAN UNIT

AND LABELS

• Clean the unit using a damp cloth with a mild

detergent.

NOTE: Do not use any strong detergents on the plastic

housing or the handle. They can be damaged by

certain household cleaners that contain aromatic

oils such as pine and lemon, and by solvents

such as kerosene.

• Wipe off the unit with a clean, dry, soft cloth.

• Keep air vents free from debris at all times.

LINE INSTALLATION

Always use genuine Ryobi 0.080 in. (2.03 mm.)

replacement line. Using line other than specified may

cause the unit to overheat or fail.

WARNING: Never use metal-reinforced line,

wire, or rope, etc. These can break off and

become a dangerous projectile.

There are two methods to replace the trimmer line:

• Wind the inner reel with new line.

• Install a prewound inner reel.

Winding the Existing Reel

1. Remove the bump head cover by pressing in both

bump head cover tabs visible on either side of the

bump head outer spool (Fig. 18).

NOTE: The spring will push the cover up when the tabs

release.

2. Remove the inner reel and spring (Fig. 18).

3. Use a clean cloth to clean the inner surface of the

outer spool (Fig. 18).

Fig. 18

Indexing Teeth

Inner Reel Hole

4. Check the indexing teeth on the inner reel and outer

spool for wear (Fig. 19). If necessary, remove burrs

or replace the reel and spool.

NOTE: Always clean the inner reel, outer spool, and

shaft before reassembling the bump head.

5. Take approximately 12 feet (3.6 m) of new trimming

line, insert one end of the line into the hole in the

inner reel (Fig. 20).

6. Wind the line, in even and tight layers, onto the reel

(Fig. 20). Wind the line in the direction indicated on

the inner reel.

NOTE: Failure to wind the line in the direction indicated

will cause the bump head to operate incorrectly.

Fig. 19

Fig. 20

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire

Ryobi 155VP Manuel de l'opérateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs et séchoirs à air Ryobi 155VP