Ryobi RY34005 Manuel d'utilisateur télécharger pdf (Page 11)

9 — English

OPERATION

BLADE THRUST

Exercise extreme caution when using a blade attachment

with this unit. Blade thrust is the reaction that may occur

when the spinning blade contacts anything it cannot cut.

This contact may cause the blade to stop for an instant, and

suddenly “thrust” the unit away from the object that was hit.

This reaction can be violent enough to cause the operator

to lose control of the unit. Blade thrust can occur without

warning if the blade snags, stalls, or binds. This is more likely

to occur in areas where it is difficult to see the material being

cut. For cutting ease and safety, approach the weeds being

cut with the brush cutter from the right to the left. In the event

an unexpected object or woody stock is encountered, this

practice could minimize the blade thrust reaction.

STARTING AND STOPPING

See Figures 6 - 8.

Trimmer should be on a flat, bare surface for starting.

To start a cold engine:

Slowly press the primer bulb 10 times.

NOTE: After the 7th press, fuel should be visible in the

primer bulb. If it is not, continue to press the primer until

you see fuel in the bulb.

Set the choke lever to the FULL CHOKE position.

With the throttle trigger at idle, pull starter handle sharply

until engine attempts to run. Do not pull the starter handle

more than four (4) times.

Set the choke lever to the HALF CHOKE position.

Pull the starter grip until the engine runs. Do not pull the

starter grip more than six (6) times.

NOTE: If the engine does not start, return to the FULL

CHOKE position and repeat the steps that follow.

Allow the engine to run for 10 seconds, then set the choke

lever to the RUN position.

To restart a warm engine:

Slowly press the primer bulb 10 times.

Set the choke lever to the RUN position.

Pull the starter grip until the engine runs. Do not squeeze

the throttle trigger to start a warm engine.

To stop the engine:

 To stop the engine, depress the STOP switch to the stop

position “ ”.

IF ASSISTANCE IS REQUIRED FOR THIS PRODUCT:

Do not return this product to the retail store where it was

purchased. Please call our Customer Service Department

for any issues you may have.

For Help Call: 1-800-860-4050

MAINTENANCE

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts can create a hazard or cause

product damage.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1, along with hearing protection.

Head protection may also be required depending on the

type of attachment used and as prescribed in the attach-

ment’s Operator’s Manual. Failure to do so could result in

objects being thrown into your eyes and other possible

serious injuries.

WARNING:

Before inspecting, cleaning, or servicing the machine,

shut off engine, wait for all moving parts to stop, and

disconnect spark plug wire and move it away from spark

plug. Failure to follow these instructions can result in

serious personal injury or property damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, lubricant, grease, etc.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 49 50

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY34005 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Ryobi RY34005