Ryobi RLH1100A MKIII Manuel de l'opérateur télécharger pdf (Page 8)

OPERATING INSTRUCTIONS

DECORATIVE TRIMMING

This trimmer has been designed and built to withstand

Decorative trimming is accomplished by removing all

normal use. It will provide many hours of service provided

vegetation around trees, posts, fences, etc. Use a

the operating instructions are closely adhered to.

30degree angle when trimming with this method (fig.

13).

Always wear eye, hearing, leg, foot and body

protection to reduce the risk of injury when

operating this trimmer.

ADJUSTING THE TRIMMING LINE

LENGTH

Your trimmer

equipped with a Bump Head that allows the

operator to release more trimming line without stopping the

motor. To release additional line. lightly tap the trimming

head on the ground (Fig. 12) while operating the trimmer at

high

speed.

Fig.

Each time the head is bumped, about 25.4 mm (1 in) of

trimming line is released. A blade in the guard will cut the

line to the proper length if excess line is released.

For best results, tap the head on bare ground or hard soil. If

line release is attempted in tall grass, the engine may stall.

NOTE: Always keep the trimming line fully

extended. Line release becomes more

difficutt as the cutting line becomes

shorter.

Fig.

EDGING

The rotating Split Boome makes it easy to use the trimmer

for edging.

Loosen the wing screws on the Split Boome coupler,

press the release button, and rotate the lower boom to

the desired position. Tighten the wing screws on the

coupler before proceeding to edge (See Fig.

page

5).

When edging, let the tip of the trimming line

the

work. Cut with the trimmer in the position shown

(Fig. 14).

Fig.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ryobi RLH1100A MKIII Manuel de l'opérateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Ryobi RLH1100A MKIII