Ryobi SAW BT3100 Manuel d'utilisateur télécharger pdf (Page 15)

Page 15

ASSEMBLY

Assembly is best done in the area where the saw will be used. When you remove the table saw base, loose parts, and

hardware from the packing materials, check all items with the loose parts list and drawing. If you are unsure about the

description of any part, refer to the drawing. If any parts are missing, delay assembling until you have obtained the missing

part(s).

ASSEMBLING LEG STAND

See Figures 8 and 9.

■ Take the following hardware from the leg stand hardware

bag:

24 carriage bolts (5/16-18 x 3/4 in.)

4 leveling feet

32 flat washers (5/16 in.)

32 hex nuts (5/16-18)

Note: Remaining hardware from this bag is used for mount-

ing leg stand on the table saw base and mounting

storage brackets to upper brace.

■ Take 4 legs and 8 braces from loose parts.

■ Place an upper side brace inside two of the legs, with the

legs wide end up. (Upper side braces have two large

holes in each end.) Make sure the two posts on the leg

align with the small holes on the brace.

Fig. 8

LEVELING FOOT

CARRIAGE

BOLT

WASHER

BOLT

HEX NUT

UPPER BRACE

LOWER BRACE

STORAGE

BRACKET(S)

HEX NUT

LEG

SCREW

WASHER

HEX

NUT

WASHER

HEX NUT

WASHER

HEX NUT

■ Align the two large holes on the brace and the legs. Insert

the carriage bolts. Add flat washers and hex nuts and

hand tighten. Repeat for the other upper brace. These are

the front and back sets.

■ For the side sets, install a upper brace on two legs. Add

hardware and finger tighten. Repeat for the other upper

brace.

■ Use the same steps to install the lower braces. Tighten all

hex nuts with a wrench.

■ Place a hex nut and flat washer on each leveling foot.

Install the leveling feet from the bottom of each leg with

the bolts pointing up. Cap with the remaining flat washers

and hex nuts but do not tighten.

■ Move the leg set to desired location. Adjust the leveling

feet with a wrench, then tighten the top hex nut.

UPPER

SIDE BRACE

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Ryobi SAW BT3100 Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi SAW BT3100