Ryobi RTS31 Manuel de l'opérateur télécharger pdf (Page 39)

ADJUSTMENTS

Fig. 57

Fig. 56

TO SET THE BLADE AT 0° AND 45°

See Figures 56 - 57.

The angle settings of the saw have been set at the factory

and, unless damaged in shipping, should not require set-

ting during assembly. After extensive use, they may need

to be checked.

 Unplug the saw.

 Raise the blade.

 Remove the blade guard assembly.

If the blade is not perfectly vertical (0°):

 Unlock the bevel locking lever.

 Loosen the 0° adjustment screw.

 Place a combination square beside the blade on the left.

The edge of the square and the saw blade should be

parallel.

NOTE: Make sure that the square contacts the flat part

of the saw blade, not the blade teeth.

 Lock the bevel locking lever.

 Tighten the adjustment screw. Check again for squareness

and continue to adjust if needed.

If the blade is not an exact 45°:

 Unlock the bevel locking lever.

 Loosen the 45° adjustment screw.

 Place a combination square beside the blade on the left.

The edge of the square and the saw blade should be

parallel.

NOTE: Make sure that the square contacts the flat part

of the saw blade, not the blade teeth.

 Lock the bevel locking lever.

 Tighten the adjustment screw. Check again for squareness

and continue to adjust if needed.

 If needed, adjust the bevel indicator to 45°.

 Make a test cut.

The adjustment screws must be below the saw table surface

so the workpiece doesn’t catch on uneven edges. If unable

to make this adjustment, take the product to an authorized

service center.

0° ADJUSTMENT

BOLT

BLADE

COMBINATION

SQUARE

BEVEL

INDICATOR

BEVEL

HANDLE

BEVEL

LOCKING

LEVER

45° ADJUSTMENT

BOLT

BLADE

COMBINATION

SQUARE

45°

BEVEL

INDICATOR

BEVEL

HANDLE

BEVEL

LOCKING

LEVER

1 2 ... 34 35 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi RTS31 Manuel de l'opérateur Page 39

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi RTS31