Ryobi RY08420А Manuel d'utilisateur télécharger pdf (Page 14)

12 — English

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE CENTER.

TROUBLESHOOTING

Problem Possible Cause Solution

Engine will not start. No spark.

No fuel.

Engine is flooded.

Starter rope pulls harder now than

when new.

Check spark. Remove spark plug.

Reattach the spark plug cap and lay

spark plug on metal cylinder. Pull the

starter rope and watch for spark at

spark plug tip. If there is no spark,

repeat test with a new spark plug.

Push primer bulb until bulb is full of fuel.

If bulb does not fill, primary fuel delivery

system is blocked. Contact a servicing

dealer. If primer bulb fills, engine may

be flooded, proceed to next item.

Allow the unit to sit for 30 minutes.

Place choke in the RUN position. Hold

throttle at full throttle and pull to start.

If unit does not start within 15 pulls,

replace the spark plug and try restarting

the engine.

Contact an Authorized Service Center.

Engine starts but will not accelerate. Engine requires approximately three

minutes to warm up.

Allow engine to completely warm up.

If engine does not accelerate after

three minutes, contact an authorized

servicing dealer.

Engine starts but will only run at high

speed at half choke.

Carburetor requires adjustment. Contact an Authorized Service Center.

Engine does not reach full speed and

emits excessive smoke.

Check lubricant fuel mixture.

Air filter is dirty.

Use fresh fuel and the correct 2-cycle

lubricant mix.

Contact an Authorized Service Center.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY08420А Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi RY08420А