Ryobi RT102 Manuel d'utilisateur télécharger pdf (Page 11)

MITER GAUGE

SLoT

BAR

ASSEMBLY

Fig. 6

ATTACHING THE UNDER TABLE GUARD

See Figure 5.



Place the router table upside down on a flat surface.

Position the under table guard around the throat of the

table.

Align the three holes of the guard with the threaded holes

in the table.

Use the hex key to secure the under table guard with

three socket head screws and three 6 mm flat washers.

ATTACHING THE FENCE ASSEMBLY

See Figure 6.

Place the router table right side up with the back edge

closest to you.

Insert the carriage bolts through the slot in the router

table and through the holes in the fence assembly.

Slide the fence lock knob washer over the carriage

bolts.

Install the fence lock knobs over the carriage bolts.

Tighten the fence lock knobs.

ATTACHING THE VACUUM HOSE

See Figure 7.

The dust ports molded into the fence will accept either a

1-1/4 in. or 2-1/2 in. vacuum attachment.

INSTALLING THE MITER GAUGE

See Figure 8.

With the router table right side up, and the front edge closest

to you, place the miter gauge bar in the slot near the front

of the table with the pointer on the right.

FENCE LoCK KNoBS

CARRIAGE BoLTS

FENCE LoCK

KNoB WASHER

FENCE

ASSEMBLY

VACUUM HoSE

DUST EXHAUST

Fig. 7

SLoT

Fig. 8

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire

Ryobi RT102 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour la vidéo Ryobi RT102