Ryobi CSB125 Manuel d'utilisateur télécharger pdf (Page 8)

8 - English

FEATURES

PRODUCT SPECIFICATIONS

Blade Diameter ...................................................... 7-1/4 in.

Blade Arbor .............................................................. 5/8 in.

Cutting Depth at 0º .............................................. 2-7/16 in.

Cutting Depth at 45º .............................................. 1-7/8 in.

Cutting Depth at 51.5º ....................................... 1-11/16 in.

No Load Speed ....................................5,000 r/min. (RPM)

Input ................................ 120 V, AC only, 60 Hz, 13 Amps

ASSEMBLY

UNPACKING

This product requires assembly.

 Carefully remove the tool and any accessories from the

box. All items listed in the Includes section must be

included at the time of purchase.

WARNING:

Items in this Assembly section are not assembled to

the product by the manufacturer and require customer

installation. Use of a product that may have been

improperly assembled could result in serious personal

injury.

 If any parts are damaged or missing, please call

1-800-525-2579 for assistance. In Mexico, please call

01-800-843-1111.

WARNING:

If any parts are damaged or missing do not operate this

product until the parts are replaced. Use of this product

with damaged or missing parts could result in serious

personal injury.

WARNING:

Do not attempt to modify this product or create

accessories or attachments not recommended for use

with this product. Any such alteration or modification is

misuse and could result in a hazardous condition leading

to possible serious personal injury.

WARNING:

A 7-1/4 in. blade is the maximum blade capacity of

the saw. Also, never use a blade that is too thick to

allow outer blade washer to engage with the flat on the

spindle. Larger blades will come in contact with the blade

guards, while thicker blades will prevent blade screw from

securing blade on spindle. Either of these situations could

result in a serious accident.

NOTICE:

To prevent damage to the spindle or spindle lock, always

allow motor to come to a complete stop before engaging

spindle lock.

ATTACHING BLADE

See Figures 1 - 3, pages 16 - 17.

 Unplug the saw.

 Depress and hold spindle lock button.

 Remove blade screw by turning it counterclockwise with

the blade wrench, while keeping the spindle lock button

depressed.

 Remove spring washer and outer blade washer (“D”

washer).

 Wipe a drop of oil onto the inner flange bushing and outer

blade washer (“D” washer) where they contact blade.

 Retract the lower blade guard into the upper blade guard

using the lower blade guard handle. Make sure the lower

guard spring works properly, allowing the guard to move

freely.

 Check to see that the saw teeth and arrow on the saw

blade and the arrow on the upper guard are pointing in

the same direction.

NOTE: The saw teeth point upward at the front of the saw

as shown.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Ryobi CSB125 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi CSB125