Ryobi CSB142LZ Manuel d'utilisateur télécharger pdf (Page 14)

14 - English

OPERATION

BEVEL CUTTING

See Figures 22 - 24, page 20.

To make the best possible cut, follow these helpful hints.

Align the line of cut with the inner blade guide notch on

the base when making 45° bevel cuts.

Make a trial cut in scrap material along a guideline to

determine how much you should offset the guideline on

the cutting material.

Adjust the angle of the cut to any desired setting between

zero and 51.5°. Refer to To Adjust Bevel Setting next.

TO ADJUST BEVEL SETTING

See Figures 22 - 23, page 20.

Unplug the saw.

Loosen bevel adjustment knob.

Rotate motor housing end of saw until you reach desired

angle setting on bevel scale.

Tighten bevel adjustment knob securely.

WARNING:

Attempting a bevel cut without having the bevel

adjustment knob securely tightened can result in seri-

ous injury.

TO BEVEL CUT

See Figure 21, page 19.

Hold the saw firmly with both hands as shown.

Rest the front edge of the base on the workpiece.

Start the saw and let the blade reach full speed.

Guide the saw into the workpiece and make the cut.

Release the switch trigger and allow the blade to come

to a complete stop.

Lift the saw from the workpiece.

POCKET CUTTING

See Figure 22, page 20.

WARNING:

Always adjust bevel setting to zero before making a

pocket cut. Attempting a pocket cut at any other setting

can result in loss of control of the saw possibly causing

serious injury.

Adjust the bevel setting to zero.

Set the blade to the correct blade depth setting.

Swing the lower blade guard up using the lower blade

guard handle.

NOTE: Always raise the lower blade guard with the handle

to avoid serious injury.

Hold the lower blade guard by the handle.

Rest the front of the base flat against the workpiece with

the rear of the handle raised so the blade does not touch

the workpiece.

Start the saw and let the blade reach full speed.

Guide the saw into the workpiece and make the cut.

WARNING:

Always cut in a forward direction when pocket cutting.

Cutting in the reverse direction could cause the saw to

climb up on the workpiece and back toward you.

Release the trigger and allow the blade to come to a

complete stop.

Lift the saw from the workpiece.

Clear corners out with a hand saw or sabre saw.

WARNING:

Never tie the lower blade guard in a raised position.

Leaving the blade exposed could lead to serious injury.

0° BEVEL STOP

See Figure 26, page 21.

The saw has a 0° bevel stop that has been factory adjusted

to assure 0° angle of the saw blade when making 90° cuts.

To check 0° bevel stop:

Unplug the saw.

Place the saw in an upside down position on a workbench.

Check the squareness of the saw blade plate to the base

of the saw using a combination square.

To adjust 0° bevel stop:

Unplug the circular saw.

Loosen bevel adjustment knob.

Loosen hex nut securing adjusting screw.

Turn adjusting screw and adjust base until square with

saw blade.

Tighten hex nut and bevel adjustment knob securely.

WARNING:

Attempting a bevel cut without having the bevel

adjustment knob securely tightened can result in seri-

ous injury.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Ryobi CSB142LZ Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi CSB142LZ