Ryobi TS1553 Manuel d'utilisateur télécharger pdf (Page 18)

ASSEMBLY

scaLe

indicator

Miter

scaLe

indicator

screw

beveL

scaLe

SQUARING THE BLADE TO THE MITER TABLE

See Figures 20 - 23.

 Unplug the saw.

 Pull the saw arm all the way down and engage the lock

pin to hold the saw arm in transport position.

 Loosen the miter lock handle approximately one-half

turn.

 Lift and hold the miter lock plate then rotate the miter table

until the pointer aligns with zero on the miter scale.

 Release the miter lock plate and securely tighten the miter

lock handle.

 Loosen bevel lock knob and set saw arm at 0

bevel (blade

set 90

to miter table). Tighten bevel lock knob.

 Place a combination square against the miter table and

the ﬂat part of saw blade.

NOTE: Make sure that the square contacts the ﬂat part

of the saw blade, not the blade teeth.

 Rotate the blade by hand and check the blade-to-table

alignment at several points.

 The edge of the square and the saw blade should be

parallel as shown in ﬁgure 21.

 If the top or bottom of the saw blade angles away from

the square as shown in ﬁgures 22 and 23, adjustments

are needed.

 Loosen the lock nut securing positive stop adjustment

screw. Also loosen bevel lock knob.

 Adjust positive stop adjustment screw to bring saw blade

into alignment with the square. See Positive Stop Adjust-

ment in the Adjustments section.

 Retighten bevel lock knob. Next, retighten lock nut

securing the positive stop adjustment screw. Recheck

blade-to-table alignment.

NOTE: The above procedure can be used to check blade

squareness of the saw blade to the miter table at both 0

and 45

angles.

The saw has two scale indicators, one on the bevel scale

and one on the miter scale. After squaring adjustments have

been made, it may be necessary to loosen the indicator

screws and reset them to zero.

Fig. 21

correct view oF bLade sQuare with Miter tabLe

view oF bLade not sQuare with Miter tabLe,

adJustMents are reQuired

Fig. 22

Fig. 23

view oF bLade not sQuare with Miter tabLe,

adJustMents are reQuired

Fig. 20

Miter

Lock

pLate

Miter

tabLe

Miter

Lock

handLe

coMbination

sQuare

bLade

beveL

Lock

knob

Miter

Fence

Miter

Lock

pLate

Miter

tabLe

Miter

Lock

handLe

coMbination

sQuare

bLade

beveL

Lock

knob

Miter

Fence

Miter

Lock

pLate

Miter

tabLe

Miter

Lock

handLe

coMbination

sQuare

bLade

beveL

Lock

knob

Miter

Fence

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Ryobi TS1553 Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi TS1553