Ryobi BT3100-1 Manuel d'utilisateur télécharger pdf (Page 16)

Page 16

ASSEMBLY

ASSEMBLING STORAGE BRACKETS

See Figure 9.

■ Take storage brackets from loose parts.

■ Take the following hardware from the leg stand hardware

bag:

4 screws (1/4-20 x 1/2 in. Pan Hd.)

4 hex nuts (1/4-20)

4 washers (1/4 in.)

■ Secure storage brackets to upper braces of leg stand as

shown in figures 8 and 9.

MOUNTING THE LEG STAND ON THE TABLE

SAW BASE

See Figure 10.

■ Take the following from a small hardware bag:

4 hex bolts (1/4-20 x 3/4 in.)

4 hex nuts (1/4-20)

8 flat washers (1/4 in.)

Note: This hardware was in the bag with hardware for

assembling the leg stand and leveling feet.

WARNING:

Do not lift the saw without help. The saw base weighs

approximately 75 lbs. Hold it close to your body. Keep your

knees bent and lift with your legs, not your back. Ignoring

these precautions can result in back injury.

■ Place the leg stand on the table saw base. Align the holes

in the table with the holes in the end braces.

■ Place a flat washer on a bolt and insert through hole. Add

a flat washer and a hex nut. Hand tighten.

See Figure 10.

■ Repeat for three remaining holes. Tighten all hardware

with a wrench. You may find it helpful to use one wrench

to hold the head of the bolt and one to tighten the hex

nut.

WARNING:

Do not connect to power supply until assembly is complete.

Failure to comply could result in accidental starting and

possible serious injury.

TO INSTALL FRONT AND BACK RAILS

See Figures 11 and 12.

■ Position end plugs on both rails and secure in place by

tapping with a block of wood or a rubber mallet.

■ Loosen the front rail clamps one half turn from the tightened

position. Loosen the square rail holder nut one-fourth

(1/4) turn to allow the front rail to slide over it.

See Figures

11 and 12.

■ Mount the front rail with the scale facing the outside

toward the operator.

LEG STAND ASSEMBLED

LEG

LOWER BRACE

UPPER BRACE

STORAGE BRACKET(S)

Fig. 9

Fig. 10

HEX BOLT

HEX NUT

FLAT

WASHER

SAW BASE

LEG STAND

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Ryobi BT3100-1 Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi BT3100-1