Ryobi BT3100-1 Manuel d'utilisateur télécharger pdf (Page 24)

Page 24

OPERATION

Fig. 26

SETTINGS AND ADJUSTMENTS

TO REMOVE THE BLADE

See Figures 25 - 27.

Use the two wrenches supplied with the saw in this proce-

dure to replace the blade.

WARNING:

Unplug your saw and make sure the blade guard assembly

is installed and working properly to avoid serious personal

injury.

■ Raise the blade guard.

■ Remove the screw from the throat plate then remove the

throat plate.

■ Push the bevel locking lever to the left for elevation mode.

■ Raise the blade to its full height by turning the blade

adjusting handle clockwise.

■ Place the open end of the small hex wrench into the slot

beside the blade. The wrench will fit over two flats on the

arbor (blade shaft).

See Figure 26.

■ Fit the large hex wrench onto the arbor nut. Turn clockwise

and remove the nut, taking care not to drag your knuckles

across the blade.

Note: The arbor nut has left-hand threads.

■ Remove the outer blade washer from the arbor and then

remove the blade. Make sure that inner blade washer and

both spacers are tight against arbor shoulder.

■ Replace with a new blade. Make sure the blade teeth are

pointing forward, toward incoming work.

■ Put the outer blade washer and arbor nut back on,

aligning with the flats on the arbor. Tighten the nut with a

counterclockwise turn.

Note: Use care not to cross thread arbor nut. Do not

overtighten.

■ Rotate the blade by hand to make sure it is turning freely.

■ Check the riving knife and adjust if needed (See next

procedure).

■ Lower the blade, insert the throat plate, then securely

tighten the throat plate screw.

BLADE

GUARD

THROAT

PLATE

BEVEL

LOCKING LEVER

BLADE

ADJUSTING HANDLE

Fig. 25

LARGE HEX

WRENCH

SMALL

SPACER

SMALL HEX

WRENCH

OUTER

BLADE WASHER

LARGE

SPACER

INNER

BLADE WASHER

ARBOR NUT

LOOSEN

NOTE: PLACE BLADE BETWEEN

INNER AND OUTER BLADE WASHER

TO ANGLE BLADE,

PUSH BEVEL LOCKING

LEVER RIGHT.

TO LOWER BLADE, PUSH BEVEL

LOCKING LEVER LEFT AND

ROTATE BLADE ADJUSTING

HANDLE COUNTERCLOCKWISE

TO RAISE BLADE, PUSH BEVEL

LOCKING LEVER LEFT AND

ROTATE BLADE ADJUSTING

HANDLE CLOCKWISE.

TO LOCK BLADE ANGLE,

PUSH BEVEL LOCKING

LEVER LEFT.

ARBOR

Fig. 27

TIGHTEN

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Ryobi BT3100-1 Manuel d'utilisateur Page 24

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi BT3100-1