Ryobi HP4720 Manuel d'utilisateur télécharger pdf (Page 12)

OPERATION

CHARGING A HOT BATTERY PACK

When using the tool continuously, the batteries in the

battery pack will become hot. You should let a hot bat-

tery pack cool down for approximately 30 minutes before

attempting to recharge.

NOTE: This situation only occurs when continuous use of

the drill causes the batteries to become hot. It does not

occur under normal circumstances. Refer to “CHARGING

THE BATTERY PACK” for normal recharging of batteries.

If the charging assembly does not charge the battery pack

under normal circumstances, return both the battery pack

and charging assembly to your nearest Ryobi Authorized

Service Center for electrical check.

TO INSTALL BATTERY PACK

See Figure 3.

 Place the direction of rotation selector in center

position.

 Place the battery pack in the drill. Align raised rib on bat-

tery pack with groove in drill’s battery port.

 Make sure the latches on each side of the battery pack

snap in place and that battery pack is secured in drill

before beginning operation.

TO REMOVE BATTERY PACK

See Figure 3.

 Place the direction of rotation selector in center po-

sition.

 Locate latches on side of battery pack and depress both

sides to release battery pack from the drill.

 Remove battery pack from the drill.

BATTeRY

PoRT

dePReSS lATCHeS To

ReleASe BATTeRY PACK

Fig. 3

lATCHeS

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Ryobi HP4720 Manuel d'utilisateur Page 12