Ryobi JM82 Manuel de l'opérateur télécharger pdf (Page 24)

24 25

1. Biscuits do not fit the slots. Biscuits not

fitting slots may also cause misalign-

ment of the boards being joined.

TROUBLESHOOTING

PROBLEM SOLUTION

A. Biscuit slots are too deep or too shallow. Make fine adjustments to depth

setting. See “MAKING FINE ADJUSTMENTS”.

B. Biscuit thickness may be out of tolerance. Compress biscuits in a vise

if they are too thick.

C. Check to see if biscuits are the correct size for the size slots that have

been cut: #0, #10, or #20.

D. Check to see if biscuits have gotten wet and have swelled.

A. The dust collection system is not functioning properly. The dust bag

may be full. Empty the dust bag often. See “INSTALLING/REMOVING

DUST BAG”.

B. The dust port may be clogged, preventing wood particles from being

drawn into the dust bag. Remove the front and rear base assemblies

and clean blade, bearing plate, base assembly slots, and surrounding

areas. See “CLEANING THE BASE ASSEMBLY AND DUST PATH”.

A. Wood particles and resin have built up on base assembly slots and sur-

rounding areas. Remove front and rear base assemblies and clean blade,

bearing plate, base assembly slots and surrounding areas. Apply a thin

coat of general purpose grease in slots or on bearing plate where base

slides. See “CLEANING THE BASE ASSEMBLY AND DUST PATH”.

A. Blade is dull. Replace the blade. See “REPLACING THE BLADE”.

B. Resin has built up on the blade. Remove the blade and clean blade with

gum and pitch remover. See “REPLACING THE BLADE”.

2. Wood particles begin to back up on the

front of the unit.

3. Blade becomes difficult to push in when

cutting slots. Blade does not retract

properly when cutting slots.

4. Cutting performance is poor and there

is a loss of power or stalling of motor

when cutting slots.

ACCESSORIES

The following recommended accessories are currently available at retail stores:

n Biscuits 100 pieces ................................................................................................................................................. Size 0

n Biscuits 100 pieces ............................................................................................................................................... Size 10

n Biscuits 100 pieces ............................................................................................................................................... Size 20

n Biscuit Assortment .................................................................................................................................. 400 pieces total

Size 0................................................................................................................................................................100 pieces

Size 10..............................................................................................................................................................100 pieces

Size 20..............................................................................................................................................................200 pieces

WARNING:

Current attachments and accessories available for use with this tool are listed above. Do not use any attachments or