Ryobi TR31 Manuel d'utilisateur télécharger pdf (Page 13)

Page 13

1/4

1/2

3/4

Fig. 12

ACCESSORIES

TRIMMING WITH SUBBASE ACCESSORY

See Figures 12 and 15.

A subbase accessory is packed in the box with your trimmer.

If desired, the existing subbase can be removed and this

accessory attached.

It is convenient when routing 4 in. (101.6 mm), 5 in. (127 mm),

or 6 in. (152.4 mm) circular grooves. It can also be used

when routing grooves parallel to the edge of the workpiece.

The handles provided allow you to grasp and hold your

trimmer with two hands similar to grasping and holding a

router.

TO ATTACH SUBBASE ACCESSORY

See Figure 12.

■ Unplug your trimmer.

WARNING:

Failure to unplug your trimmer could result in accidental

starting causing serious injury.

■ Turn your laminate trimmer upside down, remove the

four subbase screws and subbase.

■ Attach your subbase accessory using the same four

subbase screws.

■ Tighten subbase screws securely, but do not overtighten.

■ Turn your laminate trimmer upright and thread the

handles provided into the threaded holes in the subbase

accessory.

■ Tighten handles securely.

ROUTING GROOVES IN A CIRCLE

See Figure 13.

■ There are three holes marked R2", R2-1/2", and R3" on

the subbase accessory. Each number represents a ra-

dius and may be used when cutting circular grooves that

are 4 in. (101.6 mm), 5 in. (127 mm) or 6 in. (152.4 mm)

in diameter.

■ Select the radius for the desired circle, place a finishing

nail through the hole and securely tack it into your

workpiece. This will create a pivot axis for that size

radius.

■ Rout circular groove in a clockwise direction only. See

arrow shown in figure 13.

SUBBASE

SCREW(S)

SUBBASE

ACCESSORY

HANDLE(S)

LAMINATE

TRIMMER

ROUT CIRCULAR GROOVE CLOCKWISE

Fig. 13

WORKPIECE

FINISHING

NAIL

1 2 ... 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ryobi TR31 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi TR31