Ryobi RE180PL1 Manuel d'utilisateur télécharger pdf (Page 14)

ADJUSTMENTS

WARNING:

Always wear safetey goggles or safety glasses with

side shields when using your router. Failure to do so

could result in dust, shavings, chips, loose particles,

or foreign objects being thrown in your eyes result-

ing in possible serious injury. If the operation is

dusty, also wear a face or dust mask.

TO SET DEPTH STOP

■ UNPLUG YOUR ROUTER.

WARNING:

Failure to unplug your router could result in acciden-

tal starting causing serious injury.

■ Loosen lock knob and raise stop bar.

■ Rotate depth stop until the highest depth stop is

aligned with the stop bar.

■ Raise cutter by unlocking plunge lock lever.

■ Place router on flat surface, and lower router until tip

of cutter barely touches flat surface.

■ Lock plunge lock lever to position cutter at "zero"

depth of cut.

■ Lower stop bar against depth stop, then tighten lock

knob securely. The highest stop now becomes the

"zero" depth of cut setting.

VARIABLE SPEED CONTROL SELECTOR

See Figure 12.

Your router has a variable speed control selector designed

to allow operator control of speed and torque limits. You

can make speed selections best suited to the type of cut,

the material being cut, and the size of bit being used. The

variable speed control selector allows you to adjust

router speed from 15,000 to 23,000 RPM. There is a six-

step scale (A to F) on the variable speed control selector.

To increase the speed and torque of your router, turn the

variable speed control selector to a higher setting (F).

Turn to a lower setting to decrease speed and torque.

NOTE: If you do not want to use the variable speed

control selector, turn it to the highest possible setting,

and the feature will not be active.

The speed selection chart shown gives suggested speed

settings based on the diameter of the cutter and the type

of material being routed.

We suggest that you practice with the variable speed

feature of your router before installing a cutter and

making cuts in wood.

Fig. 12

VARIABLE SPEED

CONTROL SELECTOR

DECREASE

SPEED

INCREASE

SPEED

SPEED SELECTION

SIGHT WINDOW

MATERIAL

MEDIUM

1/4

3/8 1/2

3/4

SOFT

E-F D-E A-B A

D-E C-D A A

HARD

C-D B-C A A

VERY HARD D-E C-D C-D B-C

CUTTER SIZE

SPEED SELECTION CHART

ZERO RESET INDICATOR

The zero reset indicator allows you to use the scale

provided on the housing to make quick depth of cut

changes to existing depth of cut settings. Simply choose

a reference point on the scale and slide the zero reset

indicator up or down the scale the distance required for

new depth of cut. Then change stop bar position by

loosening lock knob and adjusting stop bar until red line

on zero reset indicator moves back to reference point.

Tighten lock knob securely to lock stop bar in new

position. The cutter position will now increase or decrease

the exact distance the stop bar was adjusted.

NOTE: Each mark on the inch scale indicates 1/16 in.

(1.6 mm).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi RE180PL1 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs Ryobi RE180PL1