Ryobi P551 Manuel d'utilisateur télécharger pdf (Page 13)

ASSEMBLY

WARNING:

Always make sure the compound miter saw is securely

mounted to a workbench or an approved workstand. Failure

to heed this warning can result in serious personal injury.

MOUNTING HOLES

See Figure 8.

If not using a stand, the saw should be mounted to a firm

supporting surface such as a workbench. Four bolt holes

have been provided in the saw base for this purpose. Each

of the four mounting holes should be bolted securely using

1/4 in. machine bolts, lock washers, and hex nuts (not

included). Bolts should be of sufficient length to accommodate

the saw base, lock washers, hex nuts, and the thickness of

the workbench. Tighten all four bolts securely.

The hole pattern for mounting to a workbench is shown in

figure 8. Carefully check the workbench after mounting to

make sure that no movement can occur during use. If any

tipping, sliding, or walking is noted, secure the workbench

to the floor before operating.

DUST BAG

See Figure 9.

A dust bag is provided for use on this miter saw. It fits over

the exhaust port on the upper blade guard. To install, squeeze

the two metal clips to open the mouth of the bag and slide

it on the exhaust port. Release the clips. The metal ring in

the bag should lock in between the grooves on the exhaust

port. To remove the dust bag for emptying, simply reverse

the above procedure.

trace hoLes

at these Locations

for hoLe pattern

Fig. 8

Mounting

surface

base

trace hoLes

at these Locations

for hoLe pattern

31.6

22.5

31.6

dust

bag

Fig. 9

exhaust

port

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi P551 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi P551