Ryobi P551 Manuel d'utilisateur télécharger pdf (Page 21)

OPERATION

Fig. 26

work

cLaMp

cross cut

BATTERY PROTECTION FEATURES

Ryobi lithium-ion batteries are designed with features that

protect the lithium-ion cells and maximize battery life.

If the tool stops during use, release the trigger to reset and

resume operation. If the tool still does not work, the battery

needs to be recharged.

CUTTING WITH YOUR COMPOUND

MITER SAW

WARNING:

When using a work clamp or C-clamp to secure your

workpiece, clamp workpiece on one side of the blade

only. The workpiece must remain free on one side of the

blade to prevent the blade from binding in workpiece. The

workpiece binding the blade will cause motor stalling and

kickback. This situation could cause an accident resulting

in possible serious personal injury.

WARNING:

NEVER move the workpiece or make adjustment to any

cutting angle while the saw is running and the blade is

rotating. Any slip can result in contact with the blade

causing serious personal injury.

TO CROSS CUT

See Figures 26 - 27.

A cross cut is made by cutting across the grain of the

workpiece. A straight cross cut is made with the miter table

set at the 0° position. Miter cross cuts are made with the

miter table set at some angle other than zero.

 Pull out the lock pin and lift saw arm to its full height.

 Lift the miter lock lever.

 Rotate the miter table until the pointer aligns with zero

on the miter scale.

 NOTE: You can quickly locate 0°, 15°, 22-1/2°, left or right,

31.62° and 45° left or right as you rotate the control arm.

The miter table will seat itself in one of the positive stop

index points, located in base.

 Push the miter lock lever down to lock the miter table.

 Place the workpiece flat on the miter table with one edge

securely against the fence. If the board is warped, place

the convex side against the fence. If the concave edge of

a board is placed against the fence, the board could col-

lapse on the blade at the end of the cut, jamming the blade.

 When cutting long pieces of lumber or molding, support

the opposite end of the stock with a roller stand or with

a work surface level with the saw table. See Figure 32.

Fig. 27

work

cLaMp

Miter cut

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi P551 Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi P551