23
45
OPERATION
Fig. 30
work
cLaMp
coMpound Miter cut
Fig. 31
45° x 45° coMpound Miter cut
Before turning on the saw, perform a dry run of the cutting
operation just to make sure that no problems will occur
when the cut is made.
Grasp the saw handle firmly. Depress the switch lock
with thumb then squeeze the switch trigger. Allow several
seconds for the blade to reach maximum speed.
Slowly lower the blade into and through the workpiece.
Release the switch trigger and allow the saw blade to stop
rotating before raising the blade out of the workpiece. Wait
until the blade stops before removing the workpiece from
the miter table.
TO COMPOUND MITER CUT
See Figures 30 - 31.
A compound miter cut is a cut made using a miter angle
and a bevel angle at the same time. This type of cut is used
to make picture frames, cut molding, and make boxes with
sloping sides.
To make this type of cut the control arm on the miter table
must be rotated to the correct angle and the saw arm must
be tilted to the correct bevel angle. Care should always
be taken when making compound miter setups due to the
interaction of the two angle settings.
Adjustments of miter and bevel settings are interdependent
with one another. Each time you adjust the miter setting you
change the effect of the bevel setting. Also, each time you
adjust the bevel setting you change the effect of the miter
setting.
It may take several settings to obtain the desired cut. The
first angle setting should be checked after setting the second
angle, since adjusting the second angle affects the first.
Once the two correct settings for a particular cut have been
obtained, always make a test cut in scrap material before
making a finish cut in good material.
Pull out the lock pin and lift saw arm to its full height.
Lift the miter lock lever.
Rotate the miter table until the pointer aligns with zero
on the miter scale.
NOTE: You can quickly locate 0°, 15°, 22-1/2°, left or right,
31.62° and 45° left or right as you rotate the control arm.
The miter table will seat itself in one of the positive stop
index points, located in base.
Push the miter lock lever down to lock the miter table.
Loosen the bevel lock knob and move the saw arm to
the left to the desired bevel angle.
Bevel angles can be set from 0° to 45°.
Once the saw arm has been set at the desired angle,
securely tighten the bevel lock knob.
Recheck miter angle setting. Make a test cut in scrap
material.
45
(32 pages)
(32 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels