Ryobi BTS10S Manuel de l'opérateur télécharger pdf (Page 10)

_ WARNING: I

Do not connect to power supply until assembly is

complete. Failure to comply could result in accidental

startingand possibleseriouspersonal injury.

TOOLS NEEDED

ASSEMBLING THE BLADE CONTROL HANDLE

Feed the 1/4-20 x 2-7/16" shoulder bolt through the front of

the handle so that the screw head is recessedinthe handle.

Place the M6 wing nut in the nut pocket in the rear of the

control wheel, behind the pre-drilled hole. Place your finger

over the nut to hold it in place.

Insert the screw through the hole in the front of the control

wheel. Holding the nut and screw in place, tighten with a

Phillips screwdriver.

ATTACHING BLADE GUARD ASSEMBLY

Loosen bevel control by turning bevel lock lever all the way

to the left. If it needs to be further loosened, pull spring-loaded

bevel lock lever out and rotate it back to the right. Release

bevel lock lever and allow it to seat in its original position.

Turn it to the left again until loose.

Push the handle on the control wheel in toward the saw and

rotate clockwise until the blade is set to 90° as indicated on

the bevel indicator.

Tighten bevel controlby turning bevel lock lever to the right.

If it needs to be tightened more, pull the spring-loaded bevel

lock lever out and rotate it to the left. Then release bevel

lock lever and allow it to return to its original position. Rotate

to the right again. Repeat this process until bevel lock lever

is securely tightened.

Fastenthe support bracket to the mounting bracket as shown

in Figure 4 using the two 1/2" hex head bolts and two 1/4"

external tooth lock washers. Do not tighten bolts.

Page 10

Fig. 4

Assemble the internal tooth lock washer, flat washer, and

external tooth lock washer onto the 1/4-20 x 2-1/4" socket

head bolt. Then feed the assembled bolt through the hole in

the mounting bracket and into the exposed end of the

threaded rod at the back of the saw as show in Figure 5.

Securely tighten with hex wrench provided.

NOTE: The exposed end of the threaded rod on the back of

the saw inserts into the recessed end of the mounting bracket.

WARNING:

Confirm blade guard assembly is properly aligned and all

mounting hardware is attached and securely tightened

before each use of the saw. Failure to comply can result

in serious personal injury.

Position the blade guard on the supportbracket so that the

top circular tab fits in the upper hole in the blade guard

assembly and the lower tab is in the slot. See Figure 6.

Fig. €

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi BTS10S Manuel de l'opérateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi BTS10S