Ryobi CSB124 Manuel de l'opérateur télécharger pdf (Page 12)

12 - English

OPERATION

DANGER:

If the cord hangs up on the workpiece during a cut,

release the switch immediately and allow the blade to

come to a complete stop. Unplug the saw and reposition

the cord to prevent it from hanging up again.

DANGER:

Using a saw with a damaged cord could result in serious

injury or death. If the cord has been damaged, have it

replaced before using the saw again.

CROSS CUTTING/RIP CUTTING

See Figures 14 - 15, page 18.

When making a cross cut or rip cut, align the line of cut with

the blade guide notch on the base.

Since blade thicknesses vary, always make a trial cut in scrap

material along a guideline to determine how much, if any,

you must offset the guideline to produce an accurate cut.

NOTE: The distance from the line of cut to the guideline is

the amount you should offset the guide.

TO RIP CUT WITHOUT EDGE GUIDE

See Figure 15, page 18.

Use a guide when making long or wide rip cuts with the saw.

NOTE: You may also use a edge guide to make rip cuts. Refer

to OPTIONAL EDGE GUIDE later in this manual.

Secure the workpiece.

Clamp a straight edge to the workpiece using C-clamps.

Saw along the straight edge to achieve a straight rip cut.

NOTE: Do not bind the blade in the cut.

BEVEL CUTTING

See Figures 16 - 17, page 18.

To make the best possible cut, follow these helpful hints.

Align the line of cut with the inner blade guide notch on

the base when making 45° bevel cuts.

Make a trial cut in scrap material along a guideline to

determine how much you should offset the guideline on

the cutting material.

Adjust the angle of the cut to any desired setting between

zero and 51.5°. Refer to TO ADJUST BEVEL SETTING

next.

TO ADJUST BEVEL SETTING

See Figure 16 - 17, page 18.

Unplug the saw.

Loosen bevel lock knob.

Rotate motor housing end of saw until you reach desired

angle setting on bevel scale.

Tighten bevel lock knob securely.

WARNING:

Attempting a bevel cut without having the bevel lock knob

securely tightened can result in serious injury.

TO BEVEL CUT

See Figure 18, page 18.

Hold the saw firmly with both hands as shown.

Rest the front edge of the base on the workpiece.

Start the saw and let the blade reach full speed.

Guide the saw into the workpiece and make the cut.

Release the switch and allow the blade to come to a

complete stop.

Lift the saw from the workpiece.

POCKET CUTTING

See Figure 19, page 18.

WARNING:

Always adjust bevel setting to zero before making a

pocket cut. Attempting a pocket cut at any other setting

can result in loss of control of the saw possibly causing

serious injury.

Adjust the bevel setting to zero.

Set the blade to the correct blade depth setting.

Swing the lower blade guard up using the lower blade

guard handle.

NOTE: Always raise the lower blade guard with the handle

to avoid serious injury.

Hold the lower blade guard by the handle while keeping

your hand on the front handle as shown.

Rest the front of the base flat against the workpiece with

the rear of the handle raised so the blade does not touch

the workpiece.

Start the saw and let the blade reach full speed.

Guide the saw into the workpiece and make the cut.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Ryobi CSB124 Manuel de l'opérateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi CSB124