Ryobi P507 Manuel d'utilisation et d'entretien télécharger pdf (Page 6)

6 - English

ATTACHING THE BLADE

See Figure 1, page 12.

WARNING:

A 6-1/2 in. blade is the maximum blade capacity of the

saw. Never use a blade that is too thick to allow outer

blade washer to engage with the flats on the spindle.

Larger blades will come in contact with the blade guard,

while thicker blades will prevent blade screw from secur-

ing blade on spindle. Either of these situations could

result in a serious accident.

 Remove the battery pack from the saw.

Remove the blade wrench (5 mm hex key) from the stor-

age area.

Depress the spindle lock button and remove the blade

screw and outer blade washer.

NOTE: Turn the blade screw clockwise to remove.

NOTICE:

To prevent damage to the spindle or spindle lock, always

allow motor to come to a complete stop before engaging

spindle lock.

NOTE: Do not run the circular saw with spindle lock engaged.

Wipe a drop of oil onto the inner blade washer and outer

blade washer where they contact the blade.

WARNING:

If inner blade washer has been removed, replace it before

placing blade on spindle. Failure to do so could cause an

accident since blade will not tighten properly.

 Fit the saw blade inside the lower blade guard and onto

the spindle.

NOTE: The saw teeth point upward at the front of the

saw.

 Replace the outer blade washer.

 Depress the spindle lock button, then replace the blade

screw. Tighten the blade screw securely by turning it

counterclockwise.

FEATURES

PRODUCT SPECIFICATIONS

Motor .................................................................. 18 Volt DC

Blade Diameter ....................................................... 6-1/2 in.

Blade Arbor ............................................................... 5/8 in.

Cutting Depth at 0º ............................................... 2-1/16 in.

Cutting Depth at 45º ............................................. 1-7/16 in.

No Load Speed .....................................4,700 r/min. (RPM)

ASSEMBLY

UNPACKING

This product requires assembly.

 Carefully remove the product and any accessories from

the box. All items listed in the Includes section must be

included at the time of purchase.

WARNING:

Items in this Assembly section are not assembled to the

product by the manufacturer and require customer instal-

lation. Use of a product that may have been improperly

assembled could result in serious personal injury.

 If any parts are damaged or missing, please call

1-800-525-2579 for assistance.

WARNING:

If any parts are damaged or missing do not operate this

product until the parts are replaced. Use of this product

with damaged or missing parts could result in serious

personal injury.

WARNING:

Do not attempt to modify this product or create acces-

sories not recommended for use with this product. Any

such alteration or modification is misuse and could result

in a hazardous condition leading to possible serious

personal injury.

WARNING:

To prevent accidental starting that could cause serious

personal injury, always remove the battery pack from the

product when assembling parts.

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Ryobi P507 Manuel d'utilisation et d'entretien Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi P507