Ryobi JM82G Manuel de l'opérateur télécharger pdf (Page 14)

14 − English

MAINTENANCE

CLEANING THE BASE ASSEMBLY AND DUST

PATH

See Figures 25 - 27, pages 20 - 21.

After extended use, wood particles and resin may build up

inside the base assembly of your biscuit joiner and clog the

path for wood particles going into dust bag. Wood particles

packing up in this area not only defeats the dustless feature

of your biscuit joiner, it also makes cutting biscuit slots more

difficult.

 Unplug the biscuit joiner.

 Remove the dust bag.

 Place the biscuit joiner upside down on a workbench.

 Using a screwdriver, remove the four screws and washers

securing the shoe. Remove the shoe.

 Remove the blade. See Replacing the Blade.

 With the blade removed, place the biscuit joiner right side

up. Using a pair of needle nose pliers, stretch and release

the springs from the tabs on the bearing plate.

 Using a screwdriver, remove the two screws that connect

the front and rear base assemblies.

 Carefully separate the front base assembly from the rear

base assembly. Remove the front base assembly.

NOTE: These pieces are tightly joined. It may be helpful to

use a mallet to lightly tap the area where the assemblies

meet.

 Remove the rear base assembly.

 With the assemblies separated, clean wood particles and

resin from the blade area, dust bag port, front and rear

assemblies and all surrounding areas.

 Apply a thin coat of general purpose grease in slots or

tracks on the bearing plate where the base slides.

 Replace the rear base assembly.

 Replace the front base assembly. Replace and tighten the

screws that connect the front and rear base assemblies.

 Replace the springs.

 Reinstall or replace the blade.

 Secure the shoe with the washers and screws.

 Replace the dust bag.

CLEANING THE DUST BAG

See Figure 28, page 21.

 Unplug the biscuit joiner.

 Remove the dust bag.

 Slide the clip off the end of the dust bag.

 Thoroughly clean the dust bag by shaking out all debris.

 Replace the clip.

 Replace the dust bag.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Ryobi JM82G Manuel de l'opérateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi JM82G