Ryobi RY43200 Manuel de l'opérateur télécharger pdf (Page 13)

Page 13 — English

Wipe off excess lubricant.

Check and fill the oil tank when quick view oil

indicator is below the MIN indicator line.

Repeat as needed.

NOTE: Do not use dirty, used, or otherwise

contaminated lubricants. Damage may occur

to the bar or chain.

NOTE: It is normal for oil to seep from the saw

when not in use. To prevent seepage, empty the

oil tank after each use then run for one minute.

When storing the unit for a long period of time

(three months or longer) be sure the chain is lightly

lubricated; this will prevent rust on the chain and

bar sprocket.

CONNECTING TO POWER SUPPLY

See Figure 6.

This product is designed with a cord retainer that

prevents the extension cord from being pulled

loose while using.

NOTICE:

Always use cord retainer to properly attach

extension cord to lopper. Failure to use cord

retainer may result in damage to lopper and/or

extension cord.

Form a loop with the end of the extension cord.

Insert loop portion of extension cord through

opening in the bottom of the rear handle and

place over cord retainer.

Slowly pull loop against cord retainer until the

slack is removed.

LOCK-OUT

BUTTON

SWITCH TRIGGER

CORD RETAINER

OPERATION

Plug product into extension cord.

NOTE: Failure to remove all excess cord slack

from extension cord retainer could result in plug

loosening from receptacle.

STARTING AND STOPPING

See Figure 6.

To start the motor:

 Connect the lopper to power supply.

 Use your thumb to depress the lock-out button

and fully depress the switch trigger.

To stop the motor:

 Release the switch trigger.

Fig. 6

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY43200 Manuel de l'opérateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi RY43200