Ryobi TSS100L1 Manuel d'utilisateur télécharger pdf (Page 23)

100

23 — English

Fig. 28

INDICATOR

POINT

OPERATION

TO BEVEL CUT

See Figures 28 - 29.

A bevel cut is made by cutting across the grain of the

workpiece with the blade angled to the workpiece. A straight

bevel cut is made with the miter table set at the zero degree

position and the blade set at an angle between 0° and 45°.

 Pull out the lock pin and lift saw arm to its full height.

 Loosen the miter lock handle. Rotate the miter lock handle

approximately one-half turn to the left to loosen.

 Rotate the control arm until the pointer aligns with zero

on the miter scale.

 Tighten the miter lock handle securely.

 Loosen the bevel lock lever and move the saw arm to the

left to the desired bevel angle.

 Bevel angles can be set from 0° to 45°.

 Align the indicator point for the desired angle.

 Once the saw arm has been set at the desired angle,

securely tighten the bevel lock lever.

 Place the workpiece flat on the miter table with one edge

securely against the fence. If the board is warped, place

the convex side against the fence. If the concave edge

of a board is placed against the fence, the board could

collapse on the blade at the end of the cut, jamming the

blade. See Figures 38 - 39.

 When cutting long pieces of lumber or molding, support

the opposite end of the stock with a roller stand or with

a work surface level with the saw table. See Figure 32.

 Align the cutting line on the workpiece with the edge of

saw blade.

 Grasp the stock firmly with one hand and secure it against

the fence. Use the optional work clamp or a C-clamp to

secure the workpiece when possible.

 Before turning on the saw, perform a dry run of the cutting

operation just to make sure that no problems will occur

when the cut is made.

 Grasp the saw handle firmly then squeeze the switch

trigger. Allow several seconds for the blade to reach

maximum speed.

 Slowly lower the blade into and through the workpiece.

 Release the switch trigger and allow the saw blade to stop

rotating before raising the blade out of workpiece. Wait

until the electric brake stops blade from turning before

removing the workpiece from miter table.

Fig. 29

WORK

CLAMP

BEVEL CUT

SCALE

INDICATOR

SCREW

BEVEL SCALE

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Ryobi TSS100L1 Manuel d'utilisateur Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi TSS100L1