Ryobi TSS100L1 Manuel d'utilisateur télécharger pdf (Page 32)

100

32 — English

ADJUSTMENTS

TRAVEL PIVOT ADJUSTMENT

 The saw arm should rise completely to the up position

by itself.

 If the saw arm does not raise by itself or if there is play

in the pivot joints, have saw repaired at the nearest

authorized service center.

DEPTH STOP

The depth stop limits the blade’s downward travel. It

allows the blade to go below the miter table enough to

maintain full cutting capacities. The depth stop positions

the blade 1/4 in. from the miter table support.

NOTE: The miter table support is located inside the miter table.

The depth stop is factory set to provide maximum cutting

capacity for the 10 in. blade provided with the saw. Therefore,

the saw with blade provided should never need adjustments.

However, when the diameter of the blade has been

reduced due to sharpening, it may be necessary to

adjust the depth stop to provide maximum cutting

capacity. Also, when a new blade is installed, it is

necessary to check the clearance of the blade to the

miter table support before starting the saw. Make adjust-

ments if needed.

DEPTH STOP ADJUSTMENTS

See Figure 42.

 Unplug the saw.

 To adjust the depth stop use a 10 mm wrench and loosen

the hex nut located on the top of the upper saw arm.

 Use a 5 mm hex key wrench to adjust the depth stop

adjustment screw. The saw blade is lowered by turning

the screw counterclockwise and raised by turning the

screw clockwise.

 Lower the blade into the miter table. Check blade clearance

and maximum cutting distance (distance from fence where

blade enters) to front of miter table slot.

 Readjust if necessary.

 Tighten the hex nut with a 10 mm wrench or adjustable

wrench.

 To prevent the depth stop adjustment screw from turning

while tightening the hex nut, carefully hold it with the hex

key wrench while tightening the hex nut.

Fig. 42

POSITIVE STOP

ADJUSTMENT

SCREW FOR

ANGLES

LOCK NUT(S)

POSITIVE STOP

ADJUSTMENT

SCREW FOR

ANGLES

BEVEL LOCK

LEVER

POSITIVE STOP ADJUSTMENTS

See Figure 42.

NOTE: These adjustments were made at the factory and

normally do not require readjustment.

To adjust:

 Unplug the saw.

 Using two wrenches (one on the lock nut and one for

the positive stop adjustment screw), loosen the lock nut

securing the positive stop adjustment screw.

 Loosen the bevel lock lever by turning the knob

counterclockwise.

 Square the blade to the miter table as described in the

Assembly section of this manual.

 Retighten bevel lock lever. Next, retighten lock nut

securing the positive stop adjustment screw. Recheck

blade-to-table alignment.

NOTE: The above procedure can be used to check blade

squareness of the saw blade to the miter table at both 0°

and 45° angles.

The saw has two scale indicators, one on the bevel scale

and one on the miter scale. After squaring adjustments have

been made, it may be necessary to loosen the indicator

screws and reset them to zero.

DEPTH STOP

ADJUSTMENT

SCREW

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Ryobi TSS100L1 Manuel d'utilisateur Page 32

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi TSS100L1